Does the Erickson Truck Bed Ladder Rack # EM07705 Come with 2 Uprights

Question

Question:

Erickson Ladder Racks for the 2013 Nissan Frontier Crew cab 5foot bed.. Is this for two racks/crossbars or only one rack/crossbar? Thanks,

asked by: Tom

0

Expert Reply:

The price for the Erickson Truck Bed Ladder Rack # EM07705 includes both of the ladder rack uprights that you see in the main product picture. I attached a review video for this rack for you to check out as well.

expert reply by: Jameson C

0

Answer 1

Yes, it is very likely that replacement key #THKEYN2826 will fit your Voyager XL cargo box with lock 2826. Sometimes with newer keys and older boxes the new key will have to be tapped into the lock to seat all of the way. So if they key…

view full answer...

Answer 2

The Erickson Truck Bed Ladder Rack w/ Load Stops - Aluminum - 800 lbs #EM07705 has adjustable load stops that will adjust up to 36.5 inches wide between the uprights. I confirmed this with the manufacturer. This rack will not allow you to carry a…

view full answer...

Answer 3

To slide the load stops of the Erickson Truck Bed Ladder Rack #EM07705 past the uprights of the rack you'll need to unbolt the bar from the uprights so that they could slide past. See attached picture.

view full answer...

Answer 4

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 5

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack…

view full answer...

Answer 6

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 7

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 8

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 9

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 10

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex…

view full answer...

Answer 11

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 12

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you,…

view full answer...

Does the Erickson Truck Bed Ladder Rack # EM07705 Come with 2 Uprights

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching