The Diameter of the U-Bolt in the Roadmaster Quiet Hitch for 2 Inch Trailer Hitches # RM-061

Question

Question:

What is the diameter of the rods in this device? thanks

asked by: erik

0

Expert Reply:

The U-Bolt portion of the Roadmaster Quiet Hitch for 2 Inch Trailer Hitches, # RM-061, is 11/32 inches in diameter. The thickest part of the base is 7/8 inches in diameter. The most narrow part of the base (where the nuts are) is about 11/16 inches in diameter. The inside diameter across is about 3-1/8 inches. The outside diameter across is just under 3-7/8 inches (3.819 inches).

expert reply by: Michael H

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

The first thing you'll need to flat tow your 2015 Chevy Malibu LS is a base plate kit like the Roadmaster part #RM-523178-5 that is a confirmed fit. In addition to the base plates, you will also need a compatible tow bar, safety cables,…

view full answer...

Answer 3

The total height from the bottom of the receiver tube to the top of the closed GearLocker on the Yakima Exo Swing Away Storage System #Y74ZR is 42-1/2 inches tall. I went ahead and attached a diagram that shows this height for your convenience.

view full answer...

Answer 4

That is a keen observation and a good question. I actually had the chance to assist with assembly of one of the Flint Hill Goods 30" x 50" Wheelchair Carriers #FHG99ZR not too long ago. The main bolt for the shank is indeed quite large, so…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hello Craig. I do have a solution for you, but the Flint Hill Goods Wheelchair Carrier #FHG99ZR is not recommended for use behind RVs, campers, or trailers. The ride on the back of a 5th wheel or RV is a lot more rough than on the back of a car or…

view full answer...

Answer 7

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

view full answer...

The Diameter of the U-Bolt in the Roadmaster Quiet Hitch for 2 Inch Trailer Hitches # RM-061

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching