How Big is the Opening in the Chain Links for 5,400 Pound Safety Chains 1483-535-04

Question

Question:

Could you tell me the approximate inside length of this chain? The width is 3/8 so a 3/8 bolt should fit through it. what is the opposite direction length inside to inside measurement?

asked by: Dave

0

Expert Reply:

I can't tell you the approximate inside length but I can tell you the EXACT inside length of the chain links on Safety Chain with Clevis Slip Hook # 1483-535-04. The opening is 1.27 inches long by 0.60 inches wide.

expert reply by: Michael H

0

Answer 1

I definitely understand how safety chain capacities and determining exactly what chain rating you need for your trailer can be a bit confusing. To keep it as simple as possible, safety chain requirements state that the breaking strength of EACH…

view full answer...

Answer 2

The Laclede safety chains part #1483-535-04 are made in the USA and have a 5,400 lb capacity per chain. These also have a clevis style hook. Check out the review video I attached for more info as well.

view full answer...

Answer 3

The safety chains need to exceed the loaded weight of the trailer not the axle capacity. If the loaded weight of your trailer is significantly under 3500 lbs then a 3500 lb safety chain is fine. I have attached a link to all of the safety chains that…

view full answer...

Answer 4

I went out to the warehouse and pulled Safety Chain with Clevis Slip Hook #1483-535-04. The opening at the widest point of the hook is 1-5/8 inches and at the tallest point is 2-1/2 inches. I have included a picture showing the measurements. This is…

view full answer...

Answer 5

I recommend the 42" Long Safety Chain with 5/16" Clevis Grab Hook #TCTSCG70-842-06x1 for your 21' boat trailer. You will need two of these as they are sold individually. Each chain is rated for 5,000lbs and 42" long. The 3/8"…

view full answer...

Answer 6

The Laclede Chain part #2118-605-04 would be a great option. This has more capacity than you would need at 5,000 lbs and is 27 inches long. You'd need to order two of these.

view full answer...

Answer 7

The breakaway cable should be longer than the safety chains according to RVIA Recreational Vehicle Industry Association. This will activate the brakes in the event you lose the trailer connection and the safety chains fail which will bring the…

view full answer...

Answer 8

I went out to the warehouse and measured the inside width of the Laclede 27" Long Safety Chain with 7/16" Hook, part #2118-605-04, that you referenced. The link's inside width is 1/2". I also tried to put a 1/2" bolt through…

view full answer...

Answer 9

There is no perfect calculation for safety chain length since it all depends on the setup you have. Safety chains should be crossed when attached, and also short enough to keep your coupler off of the ground should your trailer disconnect. They also…

view full answer...

Answer 10

Electric over hydraulic brake systems are basically the nicest setup around. You get the power of hydraulic brakes and the adjustability of electric. The only real cons are it will cost you more money to go this route as you will need an actuator as…

view full answer...

Answer 11

To determine the correct safety chains for your Honda CR-V towing your Dilly boat trailer you will need to consider a few things. First if you are using a Breakaway Switch #HM20060 or have a Surge Actuator #DM62VR you will need to measure the length…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

How Big is the Opening in the Chain Links for 5,400 Pound Safety Chains 1483-535-04

Product Page this Question was Asked From

Continue Researching