Can Curt Weight Distribution Shank 17123 be Used with Weight Distribution System 17002

Question

Question:

Can this ball shank be used with the Curt 17002 weight distribution hitch?

asked by: Joe B

0

Expert Reply:

Yes, you can use Curt weight distribution shank # C17123 with the Curt 17002 round bar weight distribution system. The shank offers up to 12-3/4 inches rise of 8-1/2 inches drop. The holes to adjust the head are spaced 1-1/4 inches apart on center.

expert reply by: Michael H

0

Answer 1

I recommend using the Reese Strait-Line Weight Distribution w/ Sway Control #RP66075 and Gen-Y Torsion Weight Distribution Shank #325-GH-1102 for your 2021 Ford F-250. The Reese System #RP66075 is rated for trailers with a tongue weight of…

view full answer...

Answer 2

If the battery you disconnected from your trailer is also the battery that powers the breakaway system then having the pin pulled on the switch won't be an issue. If you left the breakaway battery installed on the trailer then the pin being…

view full answer...

Answer 3

If your breakaway system uses the same batteries as the rest of your trailer it wil drain the batteries when the pin is pulled since that will activate the trailer brakes at full voltage. To prevent the drain for the time being you'll want to cut…

view full answer...

Answer 4

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

An underslung trailer coupler is one that attaches to the bottom of the trailer frame and an overslung one is one that attaches to the top of the frame. The Replacement Head for Blue Ox SwayPro Weight Distribution Systems part #BXW4011 is for…

view full answer...

Answer 7

To be completely honest the sway control feature of the B and W Continuum part #BW78FR isn't nearly as advanced as the rest of the system. The advertised sway control of this system is in the head of the system between where the ball and the…

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

It does appear you are going to be able to flip the axles on your 2023 Northern Spirit 2145RBX using 2 of the Dexter Trailer Springs Over-Under Conversion Kits #K71-384-00. I will warn you Kalvin this will raise the height of your camper roughly…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...