Troubleshooting Hopkins Impulse Brake Controller Not Operating Trailer Brakes w/ Brake Pedal  

If your axle was produced after April 2001 there should be a lot number on the axle. Go to the rear side of the axle beam about 18 inches from the curb side of the vehicle (passenger side). If you see "DEXTER AXLE" the lot…

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Hey Roy, The only U-bolt kit we currently only offer for 1-1/2" square axles is part #CE23102, which only has a 3-3/8" length so it likely wouldn't be the best option for you. Instead you'll want to order the…

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

Yes, the Replacement PlusNut Hardware Kit #Y8880039 that you referenced is an optional hardware kit for your Yakima 60" Tracks for Roof Racks #Y01135. This hardware kit is designed for use with sheet metal roof applications.

For your Capri Cowboy truck camper, you can just use any of the Thule Top Tracks for Roof Racks. Thule offers a couple of different lengths depending on the size you need. You'd have to measure the length of your roof and then pick the set…

The option that will work for your 2017 Cherokee 29TE depends on your axle diameter. For 2-3/8 inch axles, you will want the Dexter Trailer Springs Over-Under Conversion Kit, #K71-384-00. If you have a 3-inch diameter axle, you will want the kit,…

Thank you for the photos! It looks like you have an older Yakima system but we do have the Replacement Yakima Control Tower for Factory-installed Tracks #Y8890027 that will fit. This is sold in a quantity of 1 so be sure to change that to what…

The correct landing pad to go with the Tracks part #Y01127 is the Landing Pad 1 part #Y00221. Then for control towers you would need part #Y8890027 for individual towers, and then for 48 inch crossbars part #Y8810021.

Yes, the Replacement Yakima Control Tower for Factory-installed Tracks #Y8890027 will fit the now-discontinued Landing Pad 12.