Are the Wires Long Enough to Install T-One Harness 118409 on a 2004 Jeep Wrangler

Question

Question:

There does not seem to be enough wire to plug this kit into it . I do not want to pull the wires from the Jeep down right now to see if this kit will work. Is it made espically for thi Jaap and will I be able to pull the wires on the Jeep out, plug this in and put back into the area that they are in now?

asked by: Greg E

0

Expert Reply:

This wiring harness is designed to fit 1998-2006 Jeep Wrangler, also known as the TJ. I have added a link to a video of this same kit being installed on a 2004 Jeep Wrangler so you can see how it should be done. I have also added a link to the instructions that walk through the install step by step.

expert reply by: Patrick B

0

Answer 1

To add a 5-Way connector to your 2004 Jeep Wrangler Unlimited I recommend using the Tekonsha T-One #118409 and then cutting the 4-Way off and splicing in the Hopkins Endurance 5-Way Flat Trailer Connector #HM47900. You will connect these 2 wiring…

view full answer...

Answer 2

From what I was able to learn about the 2006 Jeep LJ, from 2004 to 2006 LJ was the unlimited version and had a 10 inch longer wheel base. Both can fall under the umbrella of a Wrangler so you will be able to use Tow Ready Custom Fit Vehicle Wiring,…

view full answer...

Answer 3

I spoke with my contact at MaxxAir regarding the MaxxAir 2 Vent Covers like the Smoke #MA00-933073 that you were looking at and the Standard Covers like #MA00-933067. He said there are two primary differences between the two models. The first is that…

view full answer...

Answer 4

You will need a high low adapter since basically it's okay to have up to a 3 inch height difference between the base plate attachment point and the hitch of the RV. Since you are at a 6 inch difference an adapter would be needed. To be level…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 9

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 10

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 11

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 12

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Are the Wires Long Enough to Install T-One Harness 118409 on a 2004 Jeep Wrangler

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching