Troubleshooting Bulldog Jack that The Switch Has to Be Pressed a Few Times Before it will Activate
Question:
Hi have a Bulldog 4,000 lb electric jack that seems to have an intermittent switch, motor or ground? When retracting or extending sometimes the switch is dead and needs to be rocked back and forth before engaging the jack. Could this really be the motor? Once it is engaged the motor seems to extend or retract just fine. Can I buy a replacement switche?
asked by: Jim P
Expert Reply:
It sounds like you may have an intermittent ground issue. Since the part # BD500200 grounds through the mounting hardware you will want to make sure the metal it attaches to is clean and free of corrosion.
You also want to make sure the main ground wire from the trailer connector is connected to a clean metal surface.
It might not hurt to check the power wire connection as well. Make sure it is making a solid connection.
The switches for this jack aren't offered as a replacement part.
Product Page this Question was Asked From
Bulldog Powered Drive Trailer Jack - Drop Leg - A-Frame - 22" Lift - 4,000 lbs - White
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 22 Inch Lift
- Bolt-On
- 1 Jack
- Bulldog
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Towing Mirrors
- Shop: Bulldog Powered Drive Trailer Jack - Drop Leg - A-Frame - 22" Lift - 4,000 lbs - Black
- Shop: Bulldog Powered Drive Trailer Jack - Drop Leg - A-Frame - 22" Lift - 4,000 lbs - White
- Q&A: Troubleshooting Malfunctioning Bulldog Power Jack # BD500199
- Q&A: Troubleshooting Bulldog Powered A-Frame Jack that Stopped Working
- Q&A: Landing Gear Stop Extending When They Hit the Ground but Motor Still Runs
- Q&A: Troubleshooting Electric Tongue Jack That Lights Up But Won’t Extend or Retract
- Q&A: Troubleshooting Ultimate Trailer Jack 322-RDJ-2K That Wont Slide Up or Down
- Q&A: Replacement Manual Override Lever for the Bulldog Powered Drive Trailer Jack
- Video: K Source Universal Clip-On Towing Mirror Review
- Shop: K-Source Universal Towing Mirrors - Clip On - Convex Mirror - Qty 2
- Q&A: How To Tighten the Curt 2" High Rise Hitch Ball C40034 To 450 Ft. Lbs.
- Shop: Erickson E-Chock Wheel Chocks for E Track - Powder Coated Steel - Qty 2
- Video: Race Ramps Trailer Loading Assist Ramps Review
- Shop: Trailer Hitch
- Shop: Superwinch LT3000 ATV Winch - Wire Rope - Roller Fairlead - 3,000 lbs
- Shop: Erickson E Track Tie-Off w/ D-Ring - 2" Wide x 8-1/4" Long - 1,200 lbs
- Shop: Erickson E Track Tie Down Ring - 1,333 lbs
- Video: Choosing the Right Trailer Wiring
- Shop: Trailer Wiring
- Search Results: 44649
- Article: How to Choose the Right Trailer Hitch Class
- Video: etrailer Class III Trailer Hitch Installation - 2016 Jeep Cherokee
- Search Results: 68149
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Video: Choosing the Right Brake Controller
- Search Results: 25580
- Shop: Brake Controller
- Shop: Fifth Wheel Hitch