Could Thermostat Be Used with Rampage Radiant Backseat Heater # RA3501

Question

Question:

can I add a thermastat in line on red wire to keep heated area at a constant temp and keep from running all the time? I have a very small shed about 6 feet wide and 8 feet long and pipes freeze inside in the cold winter. Ill set temp at 40 degrees Thank you.

asked by: Steve

0

Expert Reply:

As long as you have a 12 volt power source for the Rampage Radiant Backseat Heater # RA3501 you could install a thermostat switch on the power wire so that it would only come on in a certain temperature range.

expert reply by: Jameson C

0

Answer 1

I would be happy to walk you through how to calculate your power usage while powering the Rampage Radiant Heater #RA3501 overnight, but I have no way to calculate this for you as there are way too many variables. Instead you will want to follow the…

view full answer...

Answer 2

The Kat's Heaters #KH37100 that you'd looked at works very well, but at 900 watts of output it's more than you'd need for the small space you described. I'd recommend going with a 12V heater like the #KH37500…

view full answer...

Answer 3

You would need to reach out to Grand Design in order to determine the weight capacity of the rear bumper on your 2014 Grand Design Reflection 303rls. That being said, the 24x60 etrailer Cargo Carrier for RV Bumper #e99049 does include support…

view full answer...

Answer 4

The 12v cigarette lighter outlets we carry aren't going to be rated for a 25amp power draw so you would need to wire the Rampage Radiant Backseat Heater - 300 Watt - 12 Volt #RA3501 either directly to the battery with a in-line fuse holder like…

view full answer...

Answer 5

The Rampage Radiant Backseat Heater #RA3501 will absolutely work as a replacement cargo heater for your RV. This heater has a universal installation design that will allow you to wire this into any 12V power source, and can be bolted to the floor…

view full answer...

Answer 6

There are no laws I am aware of that would prevent you from mounting the TorkLift PowerArmor Locking Battery Box on top of the trailer frame. It would not hurt to contact the local DMV or state highway patrol office to confirm. On a lot of trailers,…

view full answer...

Answer 7

I looked up several pictures of 2020 Winnebago Micro Minnie 2108 FBS models and they all have easily enough room for the TorkLift PowerArmor Locking Battery Box #TLA7708R to fit as this was designed to fit campers just like the Micro Minnie. I…

view full answer...

Answer 8

The TorkLift PowerArmor Locking Battery Box #TLA7708R that you referenced is designed to fit trailer frames just like what you have so it should work very well for you. This box is universal in design and can be installed virtually anywhere. The…

view full answer...

Answer 9

Hey Doug, thanks for reaching out! The MORryde ALLTREK 4000 #MR89DR dimensions can be a bit difficult to explain via text so I've attached an image giving you the dimensions you're asking about!

view full answer...

Answer 10

Hey Chad this is a great question. So the MORryde ALLTREK part #MR89DR does offer additional vertical suspension but it does sit a little taller than the equalizers it replaces so you wouldn't have to worry about your tires hitting fenders or…

view full answer...

Answer 11

The AllTrek 4000 kits provide the best cushioning so if you were to upgrade from your CRE3000 kit to the Alltrek you would see a big improvement. If you have a 35 inch wheelbase you'd want the part #MR29DR or if you have a 33 inch wheelbase…

view full answer...

Answer 12

I can certainly point you in the right direction. We do have the #e22YR which is a 26" long 2,000 lb leaf spring. We also have the #e44SR which is a 25-1/4" long 2,500 lb spring. When replacing old leaf springs, it is critical that the…

view full answer...

Could Thermostat Be Used with Rampage Radiant Backseat Heater # RA3501

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching