Gauge Wire Used in the Curt 6-Pole Square Trailer Wiring Connector Loop # C58034

Question

Question:

What Gauge is the wire??

asked by: Mike

0

Expert Reply:

I spoke to my contact at Curt and he informed me that the Curt 6-Pole Square Trailer Wiring Connector Loop # C58034 uses 16 gauge.

expert reply by: Jameson C

0

Answer 1

There is no mounting hardware included with the Aluminum A-Frame Trailer Tongue Toolbox, item #350970, due to the different construction and mounting locations that may be required for many different styles of trailers. I would recommend using a…

view full answer...

Answer 2

The auxiliary 12-volt wire that runs from the 7-way connection to 7-way trailer plug will supply 12-volt power from the vehicle to the trailer. The 12 -volt power will allow interior or exterior lights to run that are not wired in to the…

view full answer...

Answer 3

Depending on the specific propane regulator on your trailer you will either need the MB Sturgis Propane Pigtail - Stainless Overbraid - Type 1 x 1/4 Male Inverted Flare #100833-36 or the MB Sturgis Propane Hose w/ Back Check - Type 1 x 1/4" MPT…

view full answer...

Answer 4

To make a 7-way to 6-way square adapter will require you to get the part #37995 to use the 6-way end and then wire up a 7-way to it like part #H20043. This will give you the adapter you would need since there isn't one already pre-made.

view full answer...

Answer 5

If the light bulb is disconnected from the socket, there should not be any continuity between the running lights (brown wire) and the ground (white wire). It sounds to me as if you may have a shorted or pinched wire somewhere along in the…

view full answer...

Answer 6

You will not want to connect the power wire for the wiring harness #C59496, to anything other than the battery. The reasons for this are: The kit has not been tested or rated for anything other than a connection to the battery. And connecting it to…

view full answer...

Answer 7

You should have continuity between the 5 o'clock brake output pin and 7 o'clock ground pin in your 7-way connector with the brakes applied. I recommend turning the trailer brake controller to its max setting and having someone apply the…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...