Summer Starts Here - Save up to 70%
4-1/4" Diameter round. Backup alarm provides an audible alert to anyone who might be behind your truck or van. Alert starts beeping when vehicle is put into reverse. Mounts to horizontal or vertical surface with included grommet.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to take a look at the Peterson backup alarm for trucks and vans. Anytime you have a fleet vehicle or maybe a commercial vehicle, you need to replace the alarm on the back or just upgrade a vehicle that doesn't already have one, this is going to be a great alarm for that use. It's going to have a decibel level of 102 decibels, and it's going to allow people to know that we're throwing our vehicle into reverse and they should stand clear. Comes with the grommet that you see already attached. Fits into a four and a half inch cutout, so you will have to have a cutout to get this installed. You can install it horizontally or vertically.
With the grommet in place our diameter is about four and a quarter inches across. Overall it's about one and three quarters inches deep, and going from the inside portion here, it's about an inch, maybe an inch and an eighth, or an inch and a sixteenth deep.This meets all SAUJ994 Type F specifications, has an operating voltage between 12 and 24 volts. Go ahead and demonstrate how loud this is going to be. We just have our two wires to connect. We'll have our ground wire, want to connect that to a good chassis ground, and then the red wire will be our power wire.
Now this you'll want to connect in with the reverse light switch on your vehicle. If you don't have backup lights or reverse lights on your vehicle, you'll have to put a switch in place on your own. That switch is not included with this, so you will have to pick one up separately. Connect our wires here. And if you're listening to this video with headphones, I would advise turning your volume down so this doesn't deafen you, because it's very, very loud.
And there you go. That's going to be that decibel level of 102, so it'll let people know that you're throwing the vehicle into reverse and they should stand clear. And that's going to do it for our look at the Peterson backup alarm for trucks and vans.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.