1999 Jeep Cherokee Mud Flaps

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some…

I looked up pictures of the taillights that are on the 3110 Featherlite trailers and for the LED version of them you would want the part #STL36RB and #STL37RB. It looks like the spare tire mounts for your trailer are something you would have to get…

There is a trailer wiring harness for the 2020 Ford Edge Titanium with Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part #C73FR which will plug in behind the tail lights and give you a 4-pole flat on the Edge to power…

The 22 mm size that is mentioned for the Wheelmaster lug nut part #WM9062 that you referenced is the size of the thread.

We have a really great kit that comes with everything you'd need to convert your 2021 Vanleigh Pinecrest 335RLP from tandem 6k drum brakes to electric over hydraulic disc brakes with the HydraStar Disc Brake Kit w/ Actuator for Triple Axle…

I have a solution for you, however, the jack that you referenced will not fit a 5 inch trailer tongue. The Fulton Bolt-Thru Swivel Marine Jack, #FXP15, will fit 3 inch x 5 inch trailer tongue and has a lift capacity of 1,500 lbs. This Fulton jack…

According to your owners manual, you can absolutely flat tow your specific model. It is not recommended to tow this vehicle over 65 mph. You will also need to start the engine and allow it to run for five minutes at the beginning of each day and…

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to…

Bill yes, the Brass Tire Sensors for TST TPMS #TST-507-RV-S2 will work great with your TST TPMS for RVs - Color Display - Signal Booster #TST-507-RV-4-C. These sensors were designed specifically to be used with that system as well as the 6 sensor…

The replacement reverse lock out you are looking for is the part #TK71-755-00. This would allow you to use the same adapters and fittings you have now.

The thread size is 3/8"-24 but the fitting size is 3/16". This standard for trailer brake lines. This will go from 1/2 inch thread size to 3/8 inch. If the dimensions you took are 1/2 inch and 3/8 inch of the threads this will fit.

We actually have the Brake Buddy 32220 reverse solenoid available with the Titan Solenoid Valve Replacement Kit #TK71-755-00. The solenoid itself would be an exact replacement and it features the two mounting holes at the bottom like you described…