2011 Audi Q7 3.0L V6 Gasoline Engine - Supercharged Exhaust

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric…

According to my research, your 92865A-1 hub/drum has a 25580 inner and an 14125A outer bearing and a 8 on 6-1/2 inch lug pattern, as does the AxleTek #AKHD-865-7-2-K hub drum you referenced. The #AKHD-865-7-2-K would be an acceptable replacement…

If you check out the picture I attached you can see that the roller and slide out awning assembly of the Solera RV Slide-Out Awning #LCV000435661 actually will sit below the awning rail so your setup having a tight clearance between the rail and…

Hi Bruce, To lift your trailer we'll first need to check of the…

Please note the attached instructions. The Lippert Anti-Billowing Kit for Solera Slide Topper Awnings, #LC78FR should be installed on the end of the awning that is closest to the front of the unit. 1. Make sure awning is fully retracted. 2. Place…

You sure can! You'll just need to know the brand and model of…

Hi Chris; your 2022 Ford Expedition will have a Normally Closed application, and it is possible when installing the Roadmaster Brake-Lite Relay Kit #RM-88400 that…

The best way you can determine if your 2021 Ford F-150 has LED or Incandescent lights is to call the dealer with your VIN number and they should be able to tell you. If your vehicle has LED lights, you can use the Roadmaster Universal Wiring Kit…

For vehicles where it's nearly impossible to find a dedicated…

Ultimately you do not need a converter as you can wire the tail lights on your 2022 Ford F-150 to operate as brake and turn signals just like the lights on your motorhome. You will need to use the Roadmaster Universal Wiring Kit with Smart Diodes…

I checked the owner's manual for your 2021 GMC Yukon XL, and yes,…

I advise measuring the two spindles that you have and making sure that the parts that you are wanting to interchange will be a compatible fit. I have included a photo that shows where where to take these measurements on your exiting spindles. These…