Videos
for Truck Bed Bike Racks
Help Articles
for Truck Bed Bike Racks
Expert Answers
for Truck Bed Bike Racks
Hey Randy, yes the Inno Tire Hold HD Bike Rack #IN25RR can work to carry bikes with fenders but they would need to be smaller fenders and not the longer ones you sometimes see like on cruiser bikes. Nearly all e-bike fenders will work with this…
view full answer...Yes, the Half Tailgate Pad Bike Rack part #BDW79QB that you referenced does work with your two electric fat bikes.
view full answer...I assume you're talking about the prop rods on your LEER HF650M quad fold tonneau cover, in which you'll just need the Replacement Prop Rod Assembly for Leer Tonneau Covers #LE54MR. If you're talking…
view full answer...To wire two 6-volt batteries in series to produce 12-volts, you would connect the load to the positive terminal of battery #1. Connect the negative terminal of battery #1 to the positive terminal of battery #2. Ground the negative terminal of…
view full answer...The Inno Velo Gripper Bike Rack for Truck Beds part #INRT202 has a weight capacity of 33 lbs so it would not work with an 80 lb e-bike unless the battery was removed. Instead, for a 2016 Toyota Tacoma with deck rail system I recommend the Thule…
view full answer...Yes, Curt trailer hitch #C12136 will fit all models of the 2015 Subaru Outback including yours. I have included a link to a video showing an example installation for you. If you plan on doing some towing you can use ball mount #C45521. For a 1-7/8…
view full answer...If the board were secured to the truck bed in some fashion then there should not be a stability problem using #S64700. But that is not really going to be necessary because there are bike racks that are made to be used in a truck bed. For example if…
view full answer...Yes, you can use the 4-Leaf Spring part #e22YR on your trailer. The overall length matches what you need and the capacity is close enough to your axle capacity that it would work well in that regard as well. It would have 500 more lbs than what…
view full answer...The problem you are describing on your Lippert Electric Trailer Jack part #LC285318 could be caused by a few different things. The most common problem we see that allows the light to work but not the leg is a bad ground. This could very well still…
view full answer...The Swagman Pick-Up Truck-Bed-Mounted 2 Bike Carrier part #S64702 is designed to work with the 9mm skewer setups. I am unsure but think that the Giant does use this system. To ensure check the skewer on the front axle and confirm this. It will work…
view full answer...The Curt #C93FV is intended for vehicles without LED taillights. If you have LED lights on your 2023 Kia Telluride you will need the Curt #C59236 instead. I understand you would rather have a plug an play installation, but this is the only wiring…
view full answer...For the Mopar Big Mouth the replacement wheel tray is actually the part #853-7020-56-02 which is silver and not black.
view full answer...