Inno Truck Bed Bike Racks Review - 2020 Ford F-150 Video

Because of the aggressive step through on the Townie 7D Electra bikes you will need to use a frame adapter on with the Thule DoubleTrack #TH92BJ. You'll want to use something like the Swagman Deluxe Bike Frame Adapter Bar for…

Yes, the arms you referred of the Inno Velo Gripper bike rack part #INRT201 are adjustable. In the instructions this is referred to as the bike rod and can move in and out to allow you to line the bike up as needed.

Per the Inno Instruction Manual for the Inno Velo Gripper Bike Rack for Truck Beds #INRT201, the maximum load for the carrier as whole is 1 bike or 33 lbs so unfortunately that weight capacity is not for each clamp and therefore a 51 lb bike would…

The Inno Velo Gripper #INRT201 will still work with the bike front wheel turned as long as the Gripper has something to grab onto. If it was just one Gripper holding the whole bike then there might be a stability problem. But there are 2 included so…

The Hollywood Racks RV Rider part #HLY647FR is rated for heavier bikes like your electric mountain bikes and is also rated for the rougher ride quality that is present at the rear of motorhomes. This rack has an 80 lb weight capacity and would work…

In order to get a ball mount that has effectively 0 inches of rise or drop you would need to get a Trailer Hitch Ball Mount, part #D-4, like the one you referenced that has a 2 inch drop, and then use a 2 Inch High Rise Ball, part #C40034. I attached…

If the trailer is less than 1 inch off of being perfectly level either up or down then it will be perfectly fine. Having it slightly higher would be better because presumably the tongue weight of the trailer will pull it down a little. You could also…

You should not have to make any changes to switch from the now-discontinued Prodigy RF brake controller to the factory brake controller on your 2008 Ford F-350. Of course you will not want to use the Prodigy RF's module on the front of your…

For the 2020 Chevy Colorado I recommend to use 2 sets of the Inno Velo Gripper Bike Rack for Truck Beds - Clamp On part #INRT201 which easily clamp on the bed rail and hold the bike with it's rod and ratcheting strap system. We have had a lot of…

I have a great way to locate installers near you. On each product page, there is a link that says Need help with installation? Locate installers near me." From that link, you can input your zip code and find our recommended installers in your…

The RoadActive Suspension Custom Leaf Spring Enhancement Kit like part #RAS3611-Y for your 2018 Ford F-150 only works when enough weight is placed on the vehicle's rear suspension for the leaf springs to flex. If you are using a weight…

The Inno Velo Gripper Bike Rack for Truck Beds, part #INRT202 is designed for trucks just like your 2012 Frontier. I have attached a photo of the #INRT202 for you. The small square plate( pointed out with an arrow in the photo) attached to the eye…