Hi Kat, The rubber bumpers that we offer are all 96" in length but can come in different widths. Based on the dimensions you provided i your pictures the #D3-96 is going to…

Here is a list of the tools needed to install the etrailer Enclosed Trailer Transition Plate #e32JR: - Tape Measure - Drill - Hex Drive Socket Adapter - 10mm Socket - 13mm Socket I have also added a link below to the instructions of the #e32JR for…

The etrailer Enclosed Trailer Transition Plate #e32JR is the only transition plate we carry and it does have a working load limit of 1,000 lbs. We have tested this transition plate extensively, and have found that it holds up well, even when…

If you already have a seal that you're replacing then you want to get a seal that's a similar…

The closest thing we have to a 2" x 2" bumper is the Rubber Bumper for Enclosed Trailer Ramp…

I recommend using the 601 Flooring Adhesive in a 1 Gallon #TS76FR or 4 Gallon #TS26FR depending on your application. The 601 does not have the pressure sensitive requirements of the 801, 1 Gallon #TS86FR and 4 Gallon #TS58FR adhesives.

A 3/8" self tapping screw seems a bit large for the Horse Trailer Side Pads #HTP1260BK but I do recommend always using a washer like the…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The bumper part #D3-96 that you referenced is our best option and could work for you but you will need to make some modifications. You would need to cut it down to the 84 inch length you need and would also need to drill new holes in it that line…

All of our bumper strips are 96" long and have the holes pre-drilled out at 11" on center, but…

Determining between piano hinges, #H300 3 Inch Wide Steel 6 Ft Long or #SH200 2 Inch Wide Stainless Steel Hinge 6 Ft Long, depends what features you find more important for your application. The #H300 hinge will be stronger in that it is an inch…

To test the weight of your ramp door, you will want to get the door all the way down to the ground and then on a scale of some kind (a bathroom scale can be used for this if…