Videos
for Trailer Door Parts
Help Articles
for Trailer Door Parts
Expert Answers
for Trailer Door Parts
Hi Kat, The rubber bumpers that we offer are all 96" in length but can come in different widths. Based on the dimensions you provided i your pictures the #D3-96 is going to be the best fit, but you will have to cut it down…
view full answer...Here is a list of the tools needed to install the etrailer Enclosed Trailer Transition Plate #e32JR: - Tape Measure - Drill - Hex Drive Socket Adapter - 10mm Socket - 13mm Socket I have also added a link below to the instructions of the #e32JR for…
view full answer...The etrailer Enclosed Trailer Transition Plate #e32JR is the only transition plate we carry and it does have a working load limit of 1,000 lbs. We have tested this transition plate extensively, and have found that it holds up well, even when…
view full answer...The closest thing we have to a 2" x 2" bumper is the Rubber Bumper for Enclosed Trailer Ramp Door #37210715 you looked at. This has a 2-1/2" diameter with a height of…
view full answer...If you already have a seal that you're replacing then you want to get a seal that's a similar size, otherwise if it's a brand new application then I recommend trying to find the depth of the…
view full answer...The 235/80R16 size tire, like the Karrier ST235/80R16 Radial Trailer Tire #AM34903, will measure about 30.8" for overall diameter and have a section width of 9.25". This tire/wheel combo has an 8 on…
view full answer...I recommend using the 601 Flooring Adhesive in a 1 Gallon #TS76FR or 4 Gallon #TS26FR depending on your application. The 601 does not have the pressure sensitive requirements of the 801, 1 Gallon #TS86FR and 4 Gallon #TS58FR adhesives.
view full answer...A 3/8" self tapping screw seems a bit large for the Horse Trailer Side Pads #HTP1260BK but I do recommend always using a washer like the 3/8" #01292006-020-01. This will help spread out the surface area which…
view full answer...The bumper part #D3-96 that you referenced is our best option and could work for you but you will need to make some modifications. You would need to cut it down to the 84 inch length you need and would also need to drill new holes in it that line…
view full answer...All of our bumper strips are 96" long and have the holes pre-drilled out at 11" on center, but the nice thing is these can be cut and re-drilled to accommodate your application. You just need to choose which…
view full answer...To test the weight of your ramp door, you will want to get the door all the way down to the ground and then on a scale of some kind (a bathroom scale can be used for this if it's the only thing available). This will be when the…
view full answer...Determining between piano hinges, #H300 3 Inch Wide Steel 6 Ft Long or #SH200 2 Inch Wide Stainless Steel Hinge 6 Ft Long, depends what features you find more important for your application. The #H300 hinge will be stronger in that it is an inch…
view full answer...