Videos
for RV Sewer Hose Support
Help Articles
for RV Sewer Hose Support
Expert Answers
for RV Sewer Hose Support
Each of the leaves on the Leaf Spring #e47SR are 3/8" so this will give the spring pack a height of 1-1/2". Here is a list of our U-Bolt Kits for a 3" axle. Redline #APUBR-9 Dexter #APUBR-8 CE Smith #CE23003
view full answer...The channel of the Demco 21K #DM16080-52 coupler is 3 inches deep. The distance from the center of where the trailer ball would sit to the first 5/8 inch hole is 7 inches, and 12 inches to the second hole. The Titan #T4853100 dimensions are a…
view full answer...We do carry a repair kit for the Dutton-Lainson DL-1602A trailer winch. You can use Winch Ratchet Repair Kit, #DL70455, as long as your winch was made after 1999. This kit will also fit DL1402A and DL1602ADD made after 1999.
view full answer...Yes we do have a set of Timbrens that fit your 2024 Toyota Tundra with the part #T45MR. These can give you up to an additional 6,000 lbs of suspension support.
view full answer...Hey Sandra so we've actually checked with Dometic in the past about seeing if they have replacement foot pedals for the 310 and they do not have that as a replaceable part. Only solution would be to replace the toiled or modify what you…
view full answer...I have attached a link to our selection of 8 inch trailer hub assemblies that use the common 4 on 4 inch bolt patterns for you to filter through. To choose the correct one you will simply need to remove the current hub on your trailer and check the…
view full answer...You would not be able to charge your battery through the wiring on your 4-way trailer connector. Since your truck has a 7-way connector, you could maintain the power to the battery but not charge it. To begin, you would need to cut off your 4-way…
view full answer...The 3-1/4 inch diameter hole to install the part #RR5K is the correct dimension to use. We actually even had a customer come back and say they did it with a 3 inch hole saw. I attached a link to the install video you mentioned as well.
view full answer...To replace the Level Up controller on your 2012 Dutchmen Infinity 3750FL you need the Replacement OneControl Advantage Controller #LC88TF. I confirmed this is what you're needing with my contact at Lippert!
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…
view full answer...We have had someone tell us the swivel fittings that particular hose won't fit in the 4 inch bumper of your trailer, and the manufacturer said they could grind down two of the lugs and the hose would then fit. We do have a video which…
view full answer...Hey Dave, There should be no drilling required to install the etrailer Invisible Base Plate Kit #e44FV, but there is a small section where you'll need to cut a little notch out of the bumper in order for the baseplate to fit.
view full answer...