Filter Products
Filter Results
$39.83 - $39.91
$62.85 - $551.24
Filter by Bumper or Edging
$39.83 - $39.91
$62.85 - $551.24
Videos
for Boat Dock Bumpers
Help Articles
for Boat Dock Bumpers
Expert Answers
for Boat Dock Bumpers
Yes, we do! It is the Hopkins Custom Tail Light Wiring Kit item #HM39VR. This will give you a plug and play set up to control your 2020 Jeep Wrangler's lights with your RV.
view full answer...Fifth wheel hitches can be pretty tall. Especially if you use a rail kit adapter like the #RP30156 which will add 2-3/4 inches from the floor of the truck bed to the top of the rail kit adapter. Most likely your Pullrite is going to sit too tall to…
view full answer...If your SuperGlide will work with industry standard fifth wheel rails that are 22 inches apart then the #RP30156 adapter will work for you. Some of the Pullrite hitches only fit their rails and adapters so if that is the hitch style you have then…
view full answer...The Valley 7054 hitch is pretty old so info on it is harder to come by, but we do know that it is a slider hitch and that it fits the rails that the Reese adapter part #RP30156 provides. So if you have a 7054 hitch and a Ford truck with the factory…
view full answer...A foam dock bumper such as the Taylor Made Foam Dock Bumper - Edge Mount - 36" Long x 5" Tall x 3-1/4" Thick #36946011 you asked about will do a wonderful job of protecting your boat from your floating dock, but…
view full answer...Yes, the Jif Marine Dock Corner Bumper item #JIF87VR is compatible with the Jif Marine Dock Edging - P-Shape item #JIF56VR. They are both made of marine-grade flexible poly vinyl. I recommend securing the edging every 12" both on the…
view full answer...Since the tongue of your trailer flares out you could just cut a piece of wood to match the angle of the flare to square up the tongue and then clamp-on the etrailer Round/Wheeled Swivel Jack #e79CR. If the trailer stays outside a majority of the…
view full answer...You can use springs with a lower capacity than your existing springs to help provide an easier ride for your PWC. The #SP-178275 springs are a great choice. It is important to keep in mind that going with a lower weight rated spring will reduce the…
view full answer...To choose a compatible hub assembly for any spindle the key is knowing the inner and outer bearing part numbers, or if they are not available, precise dimensions of the spindle at the points where the bearings and grease seal ride. These points on…
view full answer...The only front mount trailer hitch receiver that we offer at this time for a 2014 GMC Yukon and Yukon XL is the Curt Front Mount Hitch #C31012. This is a 2 inch hitch that offers a 9,000 lbs Line Pull capacity and a 500 lbs Vertical Load capacity.…
view full answer...The coupler I recommend for your boat trailer is the Demco Channel Tongue Trailer Coupler #12564, which fits a 3" wide channel tongue, has a 10,000 lb capacity and uses the eZ-Latch system to fit a 2" hitch ball. This will…
view full answer...Your question came in blank, but judging by the pictures you submitted it looks like your hub seal is bad and you are looking to replace what you have. To pick out the correct replacement seal you will need to use your digital dial calipers to…
view full answer...