Filter Products
Filter by Tool
$6.91 - $13.69
Videos
for Bike Tools
Help Articles
for Bike Tools
Expert Answers
for Bike Tools
We do carry a repair kit for the Dutton-Lainson DL-1602A trailer winch. You can use Winch Ratchet Repair Kit, #DL70455, as long as your winch was made after 1999. This kit will also fit DL1402A and DL1602ADD made after 1999.
view full answer...You have it right so far, the 4-way connector is just as you have stated. Remember that Yellow has a L in it so that is the left side brake/turn signal and green has a R in it so that is the right side brake/turn signal. The colors for wiring a…
view full answer...Unfortunately the Replacement Handlebar for Thule Chariot Cross, Lite, and Sport Bike Trailer/Strollers #TH24KH is not going to work with your Croozer Kid 2 Child Carrier. Since your Croozer has been discontinued for a quite a while I'd…
view full answer...I checked with Fulton and the U-bolt part #FETC0101 that you referenced has an inner length of 9-1/8 inches and an inner width of 3-5/8 inches.
view full answer...The Square Pipe Mount Swivel Jack #TJDP-7000-B uses the Replacement Pipe for etrailer and Ram Pipe Mount Swivel Jacks #TJP-OP58 which has a 2 inch inner diameter and 2-1/4 inch outer diameter. In the video the description is of the weld-on pipe…
view full answer...I have a solution for you but you're going to need to weld on a pipe mount. There are no jacks available that will clamp onto your frame and give you that much of a lift. The clamps won't support that much extension. For that high of a lift…
view full answer...For your 2015 Volkswagen Jetta we have the trailer wiring harness part #118572 which is a confirmed fit. It installs by plugging inline with the taillight harnesses of the vehicle. I attached an install video for more info on this as well.
view full answer...The overall better route will be the B and W Companion Hitch part #BWRVK3500 as long as the vehicle has a B and W Gooseneck Turnoverball hitch installed. The Companion setup is often regarded as the nicest hitch around so whenever available I…
view full answer...The best setup for your 2022 Ford F-350 would be a B and W Turnoverball Rail Kit part #BWGNRK1116 which doubles as both a gooseneck ball hitch and a fifth wheel hitch rail kit and the Companion Hitch part #BWRVK3500 which fits this rail kit. This…
view full answer...Thanks for reaching out! You can definitely modify the Yakima 54" Tracks for Roof Racks #Y01127 by cutting them and installing them in different sections, yes. To complete this installation you'll need 2 more sets of the EndCaps #Y8810103…
view full answer...The only replacement end caps available for the Yakima Roof Rack Track Systems are the Replacement EndCaps #Y8810103. These caps feature a width of just over 1-5/8 inches. If you can tell me the model number of your Yakima tracks, or if they happen…
view full answer...You can use a reducer sleeve like the #e26YR on your F-250 receiver with the e2 shank. What you don't want to do is use a reducer and extender like the #e53YR you were looking at. The extender will reduce the capacity of your hitch by 50%.
view full answer...