The Curt trailer hitch part # C11681 that you referenced has a 2,000 lb trailer weight capacity which means it would easily handle the weight of a 1,100 lb total trailer. Now I looked up the towing capacity of your 2016 Honda Accord which is rated separately from the hitch and it is only rated for towing up to 1,054 lbs so hopefully the weights you mentioned were overestimated. view full answer...
I am unable to say how close the rack would be to the ground, but I can provide you with some dimensions and you can take some measurements.
Starting at the hitch pin hole in your receiver, measure rearward 24 inches, then up 3 inches. This point will mark the extreme rearward edge of the bike rack, as shown in the photo I have edited for you. If you take a 24 inch long piece of wood like a piece of broomstick, and put it in the receiver opening with the end of it lined up with the hitch... view full answer...
The SportRack Anti-Rattle Hitch Lock # SR0901 is a 1/2 inch in diameter with coarse threads. This is a manufacturer-specific item that will only work with certain SportRack bike racks. view full answer...
I spoke with my contact at Redline and he informed me that this 10 Gauge Blue Primary Wire, part # 10-1-1, is rated for general outdoor purpose and would be considered UV exposed outdoor rated.
You would not have to worry about UV damage to this wire if you were to use it in an outside application. view full answer...
The Curt Trailer Hitch Receiver # C11496 measured in at 10" to the top of the receiver from the ground when we installed it on a 2013 Honda Accord sedan at our shop. Be aware that this height can vary slightly as suspension systems do tend to sag over time. I have linked a video below that will help you see where this is measured from as well as what is involved for the installation.
Also the hitch distance from the center of the pin hole to the rear of the bumper is 2". This will come... view full answer...
Air Lift does not rate their bags like the part # AL50236 by max and minimum height. As long as you are using the kit on the vehicle it is designed for and the vehicle isn't overloaded you just have to abide by their pressure range of minimum 5 psi and maximum 100 psi and you don't have to worry about anything else. view full answer...
According to the owner's manual for your 2006 Honda Accord Hybrid, the maximum tongue weight is 100 lbs for your vehicle. The tongue weight would include the weight of the bikes along with the weight of any carrier you place in a receiver. With the combined weight of the bikes you said you just purchased at 97 lbs, we would not have any carriers available that would keep you under the maximum weight capacity. The weight of the Hollywood Racks Sport Rider SE 2-Bike Carrier, part # HLY84FR... view full answer...
There are only Class I Hitches available for the 2010 Honda Accord. The hitch manufacturers do testing for safety and have found that the 2010 Accord can only safely carry up to 200 pounds of tongue weight.
The reason that only two bikes are recommended, on a hitch mounted bike rack, for Class I hitches is that the added torque applied to the hitch and vehicle frame will be too great for the setup, and will eventually if not immediately, cause damage to the hitch or the vehicle frame.... view full answer...
The Dexter Hub Assembly, part # 34822545BX is designed to be used with 2,000 lb axles and for 8 inch to 12 inch wheels. This assembly includes bearings, races, seal, grease cap, wheel bolts and lug nuts.
I have attached a photo of the hub and have the hub length noted on the photo. The length of the hub is 4-1/4 inches and the inner diameter of the inner and outer bearings, part # L44643, that are included with the hub measure 1 inch.
A spindle that is designed to work with the 34822545BX... view full answer...
We offer a number of hitch receivers for the 2012 Honda Accord. For reference, the link provided will take you to our main page for all hitches for your vehicle. All of these hitch receivers share a 1-1/4-inch receiver size and a Class I weight rating.
All also share a 200-lb tongue weight capacity. Tongue weight is the measure of the downward force applied on a hitch by whatever is connected to it, be it a trailer or a cargo carrier. In your case this 200-lb limit must include the weight... view full answer...
The Lock N Roll Articulating Channel Tongue Trailer Coupler item # 336TS528 would be your best option for attaching one of these systems to the Malone Mega Sport Kayak Trailer item # MPG550-AH. It fits a 2" wide channel and the channel on the Mega Sport is 2" wide. It looks like the wiring comes out of the bottom of the trailer's tongue so there shouldn't be any worries about interference. view full answer...
The shaft of the B&W Turnoverball Adapter, # BWGNXA4025, measures 4-1/4 inches long from the base and it is 2-1/2 inches by 2-1/2 inches square. This adapter was specifically designed to fit in a B&W Turnoverball gooseneck trailer hitch. view full answer...
The Wheel Masters 4-Hose Inflation Kit # WM8001-135 referenced in your question does include two stainless-steel-wrapped hoses with a 135-degree bend. These will allow for easier access to the valve stems of the outer tires on your vehicle. I have attached an image with this feature highlighted that you can take a look at.
This inflation kit will relocate the inner tire's valve stem to the outer wheel and extend the valve stem on the outer tire. A total of 4 hoses are included. view full answer...
To transport your Italian Ice cart on your 2016 Honda Accord you would need a hitch that has enough weight capacity for the combined weight of the 350-lb loaded cart plus the weight of the hitch carrier you load it on.
Unfortunately, the only hitches available for your 2016 Honda Accord are the light-duty Class I type, like Curt Hitch item # C11681, which have a maximum weight capacity of only 200-lbs. So unfortunately, there is no way to use a hitch cargo carrier on this vehicle for your... view full answer...
The bar spread of Rola roof rack 59757 is 27-1/2 inches (measured from the center of one bar to the center of the other bar).
Because the vehicle is wider at one end, the bars are different lengths. One is 1,015mm or 39.9 inches long. The other bar is 985mm or 38.8 inches long.
You can carry a 15 foot canoe on this rack provided that the canoe is within the capacity of the 2010- Honda Accord roof (check owners manual and/or Honda).
For a canoe carrier I recommend the simple Yakima KeelOver,... view full answer...
The ground clearance you would have on your 2008 Honda Accord would be right at the same amount that you currently have as the hitch will hang right at the same height as your 2008 Honda Accord.
I attached a couple pictures that show the relative height of the two.
I attached an install video for this hitch for you to check out as well. From the top of the hitch opening down to the ground measures 11-1/2 inches. view full answer...
The Swagman XTC-2 2-Bike Platform Rack part # S64670 weighs right around 33 lbs. This will actually be one of the lightest platform style bike racks we offer. It has a 3" raised shank which will help with ground clearance and it can be folded into itself for easy storage. If you would like to lock the bike rack to the vehicle then you can do so using part # S64029.
If you would like to lock this bike rack to the vehicle then you can do so using part # ACC3250. view full answer...
I spoke with my contact at Curt Manufacturing about Hitch Mounted Spare Tire Carrier, # c31006. He stated that it will hold your spare provided that the trailer hitch on the front of your vehicle is also capable of supporting the combined weight of the spare and the carrier.
He stated that basically the weight capacity of the carrier is whatever the tongue weight capacity of the trailer hitch is. view full answer...
To add a hitch to your 2019 Honda Accord Touring hybrid, you will need the Draw-Tite Trailer Hitch item # 24972 you were looking at. This hitch is custom fit and bolts to your Honda with included hardware. This is a class I hitch with a 1-1/4" receiver and the only available option for the hybrid models.
I have linked an installation video below.
To add a 4-way connector to your Honda, I recommend the Curt T-Connector Vehicle Wiring Harness item # C56402. This custom fit wiring harness... view full answer...
The top of the 1-1/4" receiver opening of Curt trailer hitch # C11525 will be about 11 inches from the ground. You can see this on the attached video. One way to decrease the possibility of bottoming out, will be to obtain accessories with some rise in the shank or choose a ball mount will some rise when towing. view full answer...
Go To Results