The blinking on the # I26 is actually correct. It doesn't make sense that the right turn signal blinks on the left and the left blinks to the right of the right turn signal light (it even sounds confusing) but that is how it's designed. You can see this in our review video below.
Based on the fact that this is working correctly it could still be the trailer side. Take a circuit tester like the # PTW2993 and check to see if you have power right behind the trailer side connector. If you... view full answer...
Looking at the vehicle you entered in the fitguide, it looks like you have a 2019 Infiniti QX60. In order to install the Saris Bones EX 2 # SAR83FR properly on your vehicle, I confirmed with Saris that you need the hatch huggers # SA3035 to replace the upper straps. For the lower straps, you can either use the hatch huggers # SA3035 or place the hooks inside the trunk.
I went ahead and attached a video that shows how the hatch huggers work. view full answer...
What you've been told is likely the culprit, and I don't believe that it's coming from an issue on the Curt # C56357 you've installed. I would check the ground wire on the trailer wiring harness to make sure that it is connected to a paint, rust and debris free spot on the trailer frame. This is the most likely cause of the sparks that you're seeing. If you can check this and see if it continues, that's a good place to start. If you're still experiencing the same issue after cleaning off... view full answer...
The T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part # 118670 which is a fit for a 2015 Infiniti QX60 is a plug-in-play harness so there isn't much to troubleshoot. The relay harness installs behind the rear, driver side interior cargo panel and the trailer connector harness installs under the rear bumper on the passenger side. There are three relay that install on the harness and two which get installed in the engine bay fuse box. I recommend making sure the harnesses... view full answer...
Thank you for all of the information!
The T-One Vehicle Wiring Harnesses, like part # 118670 for your 2020 Infiniti QX60, typically do a great job and don't malfunction often. Since you've replaced this harness already and you've checked and found your fuses to be good there is really only one other thing on the vehicle end that could be the problem and that's the OEM wiring on your vehicle (it's possible both T-One harnesses were bad but REALLY unlikely). What you'll do to test this is... view full answer...
Go To Results