Expert Answers about Chevrolet Impala

• Trailer Hitch and Wiring for a 2015 Chevy Impala LTZ
• Your assessment of the trailer hitches for the 2015 Chevy Impala LTZ are correct. Curt trailer hitch # C12115, Draw-Tite hitch # 36538, and Hidden Hitch # 90242 (no longer available) all install in a similar fashion at the same places. the Draw-Tite and Hidden Hitch models even share the same instructions. Quality wise all of the hitches meet or exceed industry standards. Some people tend to like the finish on the Curt hitches better. All three of these hitches fit both LT and LTZ models...
  view full answer...


• Base Plate Kit to Flat Tow 2008 Chevy Impala with Blue Ox Tow Bar
• We do not have any transmission components to allow a vehicle to be flat towed like a lube pump like it sounds like you need. We used to know of a company that made them but they aren't around anymore. The Blue Ox base plate kit part # BX1670 is a fit for your 2008 Chevy Impala and since you have a Roadmaster Sterling tow bar part # RM-576 the correct adapter kit you'd want is the part # RM-031-5.
  view full answer...


• CIPA Auto-Dimming Rearview Mirror with Compass, Map Lights and Temperature Display Troubleshooting
• The wiring for the CIPA Auto-Dimming Rearview Mirror with Compass, Map Lights and Temperature Display should be plugged directly into the back of the mirror. You may want to check your end connections that would have been made underneath the dash for a power and ground. The ground wire should be attached to a good metal grounding point, and the power wire is connected to a circuit that is only on with the ignition.
  view full answer...


• How Long are the Wires on the Vision X Tantrum Strobe Light Kit HIL-STW
• I called Vision X and they said that there are four 10' long cords and four 20' long cords in regards to the lights on the Vision X Tantrum Strobe Light Kit w/ Remote Control part # HIL-STW.
  view full answer...


• Will Edge Insight CS2 # EP84030 Tune a 2006 Chevrolet Impala 3.5L For More Horsepower
• The Edge Insight CS2, part # EP84030, is not a tuner type of programmer. It can display several parameters and allows you to monitor them but you cannot tune the engine with it. It will not add horsepower, torque, or change any of the factory settings on your 2006 Chevrolet Impala. It can be used with other performance chips to track and monitor your newly tuned engine. Some of the parameters you can monitor are listed below: Battery Voltage Intake Air Temperature (IAT) Engine Oil Pressure...
  view full answer...


• Does Curt Trailer Hitch Receiver for 2019 Chevy Impala Require Support Strap for Bike Rack
• Good question; the Curt Stabilizing Support Strap # 18050 is recommended by Curt, but is not required when using a bike rack on your 2019 Chevy Impala with the Curt Trailer Hitch Receiver # C12115. It will not affect the warranty on the Curt hitch if you choose not to use the strap. There was a time when this was the case for the majority of Curt hitches, but that has changed so the straps are no longer required, just recommended. It never hurts to use a strap to optimize stability but...
  view full answer...


• Recommended Wind Fairing For SportRack Square Bars
• Since the AirScreen XT for Thule Crossbars - 44" Long # TH82WV measures 44" long and will be a tight fit, I recommend going with the AirScreen XT for Thule Crossbars - 38" Long # TH72WV which measures 38" long in total and will fit between your crossbar's usable length of 41". This will simply strap onto your crossbars and will reduce wind noise and drag. I attached a demonstration video for you to check out.
  view full answer...


• Concealed Cross Tube Hitch Recommendation For 2019 Chevy Impala Premier
• I do have a hitch option for you for the 2019 Chevy Impala Premier but there is not an option available for this vehicle that is completely hidden when not in use. I recommend to use the Curt Trailer Hitch Receiver part # C12115 which is a concealed cross tube design so the only part of the hitch visible once installed is the receiver. The Curt hitch will give you a 1-1/4" receiver on the back of the Chevy and the cross tube will be hidden behind the bumper which is the most discreet...
  view full answer...


• What Trailer Hitch Will Fit On My 2011 Chevrolet Impala
• Without knowing exactly what trailer hitch you have on your 2004 Chevrolet Impala I don't know if it will work on your 2011. However, two out of the three trailer hitches we carry for the 2004 Impala are also compatible with the 2011 Impala, the Draw-Tite Class II Frame Receiver Hitch # 36407 and the Curt Class II Receiver Hitch # C12252. If your hitch is not one of these then it may not fit and you would want to purchase one of the hitches above. Between the two hitches I would suggest...
  view full answer...


• Recommended Trailer Hitch Receiver For 2005 Chevrolet Impala
• I have another option for you but the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" # C13315 you were looking at is only confirmed to fit select Mazda CX-5's. There is not a class III hitch available for your 2005 Chevrolet Impala so I recommend the Draw-Tite Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4" # 36407. This hitch has a 300lb tongue weight rating and 3500lb trailer weight rating so it will be perfect for carrying a bike rack, cargo carrier, or even a ball...
  view full answer...


• Bolt Leader and Wiring Harness for a 2007 Chevy Impala
• All of the hitches sold on our website come with the necessary hardware to install the hitch on its respective vehicle, but do not include the tools. If you should decide you need to purchase a bolt leader for the installation of the Draw-Tite Class II Trailer Hitch Receiver, item # 36407, you will need the 1/2 inch Bolt Leader, part # 80101-1. The T-One Wiring Harness for your 2007 Chevy Impala is sold separately from the hitch, and it is the T-One Vehicle Wiring Harness, item # 118417....
  view full answer...


• Trailer Hitch And Cargo Carrier For 2013 Chevrolet Impala
• For your 2013 Chevrolet Impala, the Curt Trailer Hitch, part # C12252, is a good fit. This requires no drilling for installation and has a 1-1/4 by 1-1/4 inch hitch receiver opening. This is a Class ll hitch. I did some research and found that the maximum towing capacity for your Impala is 1,000 lbs. Tongue weight is approximately 10 percent of the towing capacity so you can carry about 100 lbs, including the weight of the carrier you place in your hitch. You will want to either consult...
  view full answer...


• Best Trailer Hitch for Use with Bike Rack on a 2014 Chevrolet Impala LTZ
• The best trailer hitch we have for your 2014 Chevrolet Impala LTZ is the Draw-Tite Trailer Hitch Receiver part # 36538 which is a custom fit and will not require any drilling. The Draw-Tite option is a Class II hitch with a 1-1/4" receiver tube opening. I like the Draw-Tite hitches as they do not require the use of an added support strap like the Curt hitches will. You can see how it installs using the attached video on a similar 2015 Chevrolet Impala. Please note that you will be limited...
  view full answer...


• 1-1/4-Inch Class II Hitch Bike Rack for Heavy Schwinn Bike
• The hitches made for your 2007 Chevrolet Impala are the 1-1/4-inch Class II type, Draw-Tite # 36407 and Curt # C12252. Both offer the same weight capacity of 300-lbs tongue weight and both are no-drill bolt-on installations using included hardware. The Curt hitch is made here in the USA. You will need to use a Class II-rated hitch bike rack; all such carriers appear on the linked page. Most bike racks, like the Swagman XTC # S64670, top out at a 35-lbs bike weight rating but we do have...
  view full answer...


• Does the WeatherTech Floor Liners # WT441241 Include the Driver and Passenger Side Mats
• The price listed on the product description page for the # WT441241 WeatherTech Front Floor Liners includes the drivers and passenger side floor liners.
  view full answer...


• Best Way to Carry Bikes with a 2014 Chevrolet Impala LT
• Yes, you are correct your 2014 Chevrolet Impala LT will need a Class II 1-1/4 trailer hitch such as the Draw-Tite Class II Hitch Receiver # 36538. I recommend the Draw-Tite over the Curt, because Curt requires the Curt Trailer Hitch Support Strap # 18050 to be used with any non-trailer loads. This is within the guidelines of their warranty. I included an installation video on a 2015 Impala which will be similar to yours. In order to carry your 2 inch bike rack with this hitch you will...
  view full answer...


• How To Order Replacement Hardware Kit For Curt Trailer Hitch
• We do have a replacement hardware kit for your Curt Trailer Hitch, part # C12252. Just enter # RHK in the search box on our website. Then enter C12252 in the Hitch Item Number box. Select Curt From the dropdown box and order the quantity replacement hardware kits you want. Your hardware kit will be assembled for you. It's that easy.
  view full answer...


• Base Plates, Tow Bar, Safety Cables, and Wiring to Flat Tow a 2007 Chevy Impala LTZ
• You will be able to flat tow your 2007 Chevy Impala LTZ using a tow bar. You will first need to install base plate kit # 523133-1 (only works on models with 3.5 liter motor). You will then need a tow bar compatible with EZ style base plates. I recommend the RoadMaster Tracker Tow Bar, # RM-020. (To be able to remove the EZ base plate front extensions, you will need to use Roadmaster Tow Bar Quick Disconnect Kit, # RM-201.) Next, you will need safety chains, or cables, and a light kit...
  view full answer...


• Parts Needed to tow PWC Trailer with a 2015 Chevy Impala LTZ
• We have exactly what you will need. But before that I wanted to thank you for looking up the towing capacity of your vehicle beforehand as that is a very important step many people ignore. The Curt Class II hitch part # C121115 is confirmed to fit your 2015 Chevy Impala LTZ and would work well for your needs. I attached an install video for you to check out as well. If the trailer you plan to tow calls for a 1-7/8 inch hitch ball you would want the ball mount part # C45571 or for a 2...
  view full answer...


• Brake Controller and Wiring Harnesses Recommended for My 1967 Chevy Biscayne Wagon
• For a great brake controller for your 1967 Chevrolet Biscayne Wagon, I recommend the Curt Echo # C51180. Not only is the Curt Echo smart phone controllable, it has a super easy plug-and-play installation into your 7-way plug. While the vast majority of brake controllers require a plug-in harness that requires additional splicing, you will not have this headache with the Echo. On top of all that, it is completely assembled in the U.S.A. In order to install a brake controller on your vehicle,...
  view full answer...