It's not likely your International has a factory connector for an electric brake controller adapter. But you can still install a Prodigy P3 # 90195 by hardwiring it into the RV.
You will wire the P3 in by connecting the black wire to the positive side of the RV's battery, the white will need to be grounded which can be done to the negative side of the battery, the blue goes to the trailer connector at the back of the RV and red goes to the cold side of the stop light switch. The stop... view full answer...
Yes, since you already have a 6-way trailer connector installed that has some of its connection made, just those for basic trailer lighting, you need only to make the two additional connections for the output circuit from a trailer brake controller and for the 12V trailer auxiliary power circuit.
On a brake controller like the Prodigy P3 # 90195 the blue output wire will need to be routed to the 6-way, to either the center pin or the pin at the 10:00 position. This depends on how your... view full answer...
One of the best brake controllers we offer is the Tekonsha Prodigy P3, part # 90195, because it is so easy to install and operate. This will work with electric or electric over hydraulic brakes. Since the Winnebago Journey Motorhome is built on a 2006 Freightliner XC-Series Chassis, the # 3027-P harness is the correct harness to use.
If your Winnebago Journey already has a 4 and 7-way trailer connection, one end of the custom adapter plugs into your vehicle, and the other end plugs into... view full answer...
For the 3.0L Engine on your 2008 Freightliner Sprinter 3500 you will need the external heater # KH13150 as there are no cartridge-style heaters available.
This is designed for 26 - 40-qt coolant systems and works to keep the fluid to your engine block, heater core, and radiator warmed for easier start-ups. The heater comes with a mounting bracket, hose clamps, 1 Y-tube, and 1 hose fitting as well. It is made in the USA and also comes with a 1-year limited warranty.
Please note that you... view full answer...
For 6 internal tire sensors with a monitor, you'll want to use the TST TPMS - Color Display - Signal Booster - 6 Internal Tire Sensors # TST-507-INT-6-C.
This kit includes 6 internal tire sensors, and also includes a color wide screen monitor. view full answer...
For the 144-inch-wheelbase 2016 Freightliner Sprinter 2500 with step bumper we offer the 2-inch Class III Curt hitch # 13358. This installs without drilling and it includes all required mounting hardware. Note this hitch will NOT fit frames that are 30-3/8-inches wide measured outside to outside.
For a trailer brake controller I suggest the user-friendly Prodigy P2 # 90885 along with our 7-way installation kit # ETBC7. You will also need to first install a 4-pole harness # C59496. These... view full answer...
We do have a number of options for heavy-duty booster cables, and you can make the choice about what you need based on the length you need, as well as if you want the 1-gauge wire or 2-gauge wire. Your options are:
- 1-Gauge Wire, 30 Feet Long: Bulldog Winch Booster Cable Set # BDW20333
- 1-Gauge Wire, 20 Feet Long: Bulldog Winch Booster Cable Set # BDW20332
- 2-Gauge Wire, 24 Feet Long: Deka 2 Gauge Professional Service Booster Cables # DW00161
- 2-Gauge Wire, 20 Feet Long: Bulldog... view full answer...
The first thing to do is check your Fleetwood owner's manual to confirm that your specific Discovery motorhome model has the towing capacity for your 34-foot triple axle race trailer. I was able to find a copy of the Fleetwood base manual online but it did not include a gross trailer weight (GTW) spec. Many motorhomes top out at a 5K tow rating so you definitely want to check with Fleetwood using your VIN.
To install an electronic trailer brake controller in the MH you will need to access... view full answer...
You will need the Curt Class V Universal Weld-on Receiver Hitch # 15902 for your 2015 Freightliner M2. This will allow you to weld on a receiver with up to 10.865" of drop. For the trailer lighting you will need a combination of the Curt Powered Tail Light Converter # C59236 and the Universal Installation Kit # ETBC7 to get to a 7-way blade trailer connector. Do note the wiring to reach the battery is 25' long so if your chassis is longer you will need additional Wire # 10-2-1 to reach... view full answer...
When it comes to upgrading your class 2 trailer hitch on your 2005 Coachmen Cross Country I recommend The Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver - Weld On - Class V - 2 inch # 41990-07.
This trailer hitch welds onto the frame of your trailer and will give you a 1,600 pound tongue weight. view full answer...
We can help you set up your 2002 Alfa SeeYa motorhome with a hitch receiver and related items for towing a trailer. Towing requires a hitch, ball mount, hitch ball and wiring to activate the trailer's lights. The linked article covers these basic towing items.
We have hitches for RVs that are shown on the linked page. You will want to use a frame-mount type since these have the highest capacity. Check your RV frame width to help you choose the best fit. For example, Curt hitch # C13701... view full answer...
You do have the option to utilize the air brakes on your 2023 Freightliner Cascadia to control electric trailer brakes using the Hayes Air Actuated Trailer Brake Controller, part # HA100400C. However, we mostly recommend just using an electric brake controller since they tie into the stop light switch of the tow vehicle, making it irrelevant what kind of brakes it has.
For an electric brake controller I recommend the Tekonsha Prodigy P3 # 90195. A very solid, user friendly brake controller.... view full answer...
There are several different Freightliner chassis types used for RVs, such as the popular XC-series that is often used for Class A diesel motorhomes. This chassis can allow for plug-and-play installation of a trailer brake controller such as the Tekonsha Primus IQ Trailer Brake Controller # TK90160 so long as the RV has a factory tow package.
In this case you will use wiring adapter part # 3027-P to connect the Primus to the under-dash port. This adapter also fits 2004 - 2015 Freightliner... view full answer...
If you already have a Curt brand brake controller, then the good news is all you will need to install the Curt Spectrum Brake Controller # C51170, is the brake controller. The chassis of your motorhome really doesn't matter at this point because all you need to do is unplug your current brake controller, plug in the main module and find a suitable location for the control knob.
I'm not sure what year your motorhome is, but most Valencia's have some space just to the left of the driver... view full answer...
Thanks for the photo of your Prodigy P3 # 90195. That will work well for your application. You will also need a wiring harness that can handle multiplex systems like the ZCI Circuit Protected Vehicle Wiring Harness w/ 4-Pole Flat Trailer Connector and Installation Kit # 119250KIT and then the Brake Controller wiring kit # ETBC7. This wiring harness will capture the light functions needed and then the brake controller wiring kit will give you the 7-way and circuit breakers you need to... view full answer...
If your 1999 Winnebago Chieftain motorhome has the air suspension, solid front axle and is not equipped with the 150 gallon fuel tank, the Roadmaster Reflex Steering Stabilizer, part # RM-RBK14-RSSA, you have referenced, is the correct part for your application.
This part number # RM-RBK14-RSSA, will include the stabilizer # RM-RSSA, and the mounting brackets # RM-RBK14. view full answer...
A 1995 Freightliner will not have a brake controller port. In order to install one you will need to add a 7-way, and to do this you'll need the following:
- Tail Light Converter with 4-Pole Flat Trailer Connector # C59236
- Universal Installation Kit for Trailer Brake Controller # ETBC7
You will first install the 4-flat, which will activate your trailer's lighting functions, and you'll then plug that into the 7-way that comes with the # ETBC7, which also gives you the wiring, circuit... view full answer...
Go To Results