SuperSprings Custom Suspension Stabilizer and Sway Control Kit

by: Deb G08/31/2017

2001 Ford F-250 Super Duty

I bought this product for my 2001 F250 that I use to haul a 24' gooseneck horse trailer typically loaded with about 3000-4000 lbs of cargo.
My truck was squatting and I was experiencing sway, expecially on the interstate when passing tractor trailers.
The super springs greatly improved my truck's suspension and performance when hauling. I would highly recommend this product. 427319

1750314

1428204

977380

Installing these on a 2020 F250 was easier than I thought it would be. I was able to get the springs on whit the center piece and the front shackle bolted without jacking up the truck. I had to jack the frame up a few inches on each side to get the back shackle bolt through. I put the shackle bolts through the bottom holes since I only need the extra support when I tow. I recommend air / power tools for the shackle nuts and it doesn’t hurt using them for the center bracket u bolts. They are lock nuts and they have a long way to run on for each bolt. I did have to bend my parking brake cable hangar out a bit for one of the shackle bolts to clear the cable. The truck seems to sit a little higher in the back. Maybe an inch or so. The ride empty seemed the same except it felt like it didn’t roll quite as much when turning. Rolling over a lip at the end of our driveway the extra stiffness was noticeable, however. I won’t know how well they really work until I get my fifth wheel hooked up.1770524

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

by: Howard10/24/2019

The Super Springs work great! I pull a 8,500# trailer with a hitch weight of 950# with a 2004 GMC Sierra 1/2 Ton. The truck pulls fine but even with an equalizer hitch still had some sag. The Super Springs were easy to install and leveled the rig. After a year everything still works great.720061

Click to Enlarge

Click to Enlarge

No issues with install on a 2023, E350 Class C motorhome.
After chalking the front wheels, I used two 3 ton floor jacks with 13” 6x6 blocks just behind the springs to lift the frame and rear tires off the ground to remove the wheels. For safety, 3 ton jack stands were put under the axles during spring installation
After installing the springs per manufacturer instructions, two 1/2” x 10” pieces of all thread with drilled flat bar were used to compress the front end spring.
With the least amount of preload it raised the back a good inch.
The 800# trailer tongue weight will be the next test to see if more preload is needed for a level ride height.1539290

Click to Enlarge

The kit looks really good but I can’t figure out how to install. Enclosed are two photos showing my van suspension and the parts your sent. The instructions do not show my van with only one spring. Can you advise?????????????? Thanks. 603418

Click to Enlarge

Click to Enlarge

Added these springs to my 2500 Silverado to prepare for a slide in camper. They made quite a difference. I did it myself, but two people would be easier. The ride is naturally a little stiffer when empty, but that's the trade off.1768065

by: Rich08/20/2020

Installed on a 2016 Toyota Tundra. I pull a 28 foot aluminum frame utility trailer. Hauls like a 3/4 ton with super spring. Rides like 1/2 ton without load. I have put 1 ton load on truck with no trailer and the truck drove fine. The front of truck at tires rose 1/2 inch. Installation requires the frame to be lifted off the axel.at rear of vehicle. I like this system better than air shocks as there is no adjustment after installation. I would purchase again.865324

Click to Enlarge

Click to Enlarge

I got this to prevent bottoming out my truck when towing our travel trailer. Won't know for sure if this actually works until we load up. Having said that, the instructions provided with this are poor and talking with Supersprings tech support was frustrating. As mentioned elsewhere, you will need two "C" clamps to pre-load the spring and I wound up fabricating a 3" extension bracket for the brake lines; neither of which were mentioned in the instructions. I also removed the wheels to provide working space and air tools are definitely the way to go. On my '13 Tundra, the distance between the stock spring pack straps is 40" the same as the distance between the eyes on the Superspring. I was advised that the spring is mounted off-center to avoid conflict with the stock spring straps; however this in not mentioned in the instructions. This placed the Superspring about 4" forward of the center of the axel instead of centered on the axel. (see photos) This seems counterintuitive to me but we'll see. This added 1.5" in height to the rear of the truck. It took me 4 hours to install by my self, including time to fabricate the brake line extensions and dealing with Supersprings staff twice on the phone. During the second call, the tech mentioned that they get a lot of phone calls for Tundra installs, indicating to me that they already know there are issues with the product and instructions. In retrospect, I would look for a new spring pack if I was doing this again. Hopefully my suspicions are unfounded but I'm hanging on to the box just incase. Etrailer was great with the best price anywhere and quick shipping. 108092

Click to Enlarge

Click to Enlarge

This was by far the easiest mod I have made to my 2019 Ford Super Duty King Ranch! Only took 45 minutes start to finish. Didn't even take the wheels off. Took some pressure off of the springs by lifting the rear end a little using the trailer hitch. Used the bottom holes on both ends and only raised the rear of the body 1 inch. Great product!1088127

Click to Enlarge

Click to Enlarge

i have these on a couple of trucks and they work great.more reliable than air bags1762965

Great product, very clear instructions. I really appreciated the stickers on each spring showing the correct orientation, that took all of the guess work out of it.

Thanks Supersprings for making a great kit and confirming the product would work with the airbags I had installed.1705464

Product worked as described. Shipping was quick (etrailer used "air" to my state, then on UPS truck)
Easy to install, not sure why they included 2 sets of polyurethane blocks (only one set fit my truck)
Don't notice any ride difference when set at lowest setting. Raised truck approximately 3/4". East to readjust for more preload if needed.
Combined these Super Springs with Timbren load handlers. So far so good.
Great improvement over stock while maintaining ride quality.785262

Click to Enlarge

Click to Enlarge

Click to Enlarge

by: Joseph 12/30/2023

This helped immensely with the wondering in the steering of my e350. The shop that I had install it has been recommending this to their customers1706417

E-trailer agent James helped find trailer tow package that fit my 2011 Ford Transit Connect and provided appropriate install video. You're a huge help James. The install went smoothly without a hitch (lol).650553

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Pretty sweet. Immediate and noticeable improvement for my sprinter conversion. Disappointed I waited so long to install.1741130

by: Ted 10/10/2017

These springs improved the ride considerably , less roll on corners with the slide in camper on and wheel hop on rough roads . In general the handling was much improved.441128

Click to Enlarge

by: Gary 08/23/2023

SuperSprings were a great addition to our van. Sway control improved immediately with the SuperSprings. The process to install SuperSprings was moderately challenging but my son and I got them installed at home. Purchasing a set of C-clamps made it possible. Definately worth their price!1652710

I am 100% pleased with etrailer...received wrong suspension because of manufacturer's misrepresentation...Tiffany at etrailer corrected everything...sent a prepaid UPS label to send it back...sold me the proper stabilizer springs...and gave me 100% credit back on the wrong purchase...these people are true to their word and I recommended them to everyone...P.S. today I installed the new stabilizers and they work like a charm...and...I talked to Tiffany on Monday the 9th...received the new stabilizers on Wednesday the 11th and installed them on Thursday the 12th...10 thumbs up to Tiffany and etrailer...thanks,1680535

Had a pro install them to the center hole like Manufacturer suggest, rides a little firmer which I like not sloppy, Have not towed yet but looking forward to it! Great products and fast shipping.1102454

Click to Enlarge

Click to Enlarge

Click to Enlarge

Overall, the installation of the SuperSprings kit went pretty well. The instructions sent with the kit were not all that clear, but the info on etrailer's website saved the day. Can't wait to put the camper back on the truck and see how it rides!717705

Click to Enlarge

Click to Enlarge

by: Richard W02/07/2020

I bought this item for my 20 year old 37' motor home. Over the years the rear end has "squatted" down some and due to the weight of the frig, washing machine, and a small freezer all being on the passenger side, it was lower on that side. Installation was not the easiest thing, but this 70 year old was able to do it by myself, even on a gravel driveway. Installation instructions are good. Besides the drive axle, my rig has a second, "drag" axle, whose tires I had to remove to do the job. I also had to re-route a propane line. The hardest part was Step 7: "Using a heavy duty C-Clamp or SuperSprings installation tool, pull down rear of SuperSpring and install bolt,..." I used 2 C-Clamps and it was pretty tricky. I'm not sure what the price of their special tool is and I don't think etrailer sells it. I used the bolt hole that gave me the maximum lift on the passenger side and the first hole on the driver's side. The completed installation did accomplish my goal of leveling the motor home. These springs are really heavy-duty and very good quality. I have no complaints.748876

If you watch the video on installation from the model - SSA13MXKT, you will see how to install them, that's why I don't have any pictures. It took me about 2-1/2 hours to install. The brackets were a plated color and I painted everything black before installed them. My truck was pretty clean underneath so I think they look better. I installed them on a 2019 GMC Denali HD 2500 Duramax. As far as handling, after the install, I did not notice too much difference empty. But - when I had my 5th wheel hooked up, there was a difference, not a significant amount, but a difference. My pin weight on the trailer is roughly 1,350 lbs. also. Now for the dimensions here is what I got - I would say, these dimensions are within an 1/8". The dimensions were taken from the center of the tire to a line on the truck, front and rear.
BEFORE INSTALL -
Rear - 43"
Front - 40-1/8"
AFTER INSTALL -
Rear - 44"
Front - 40-1/16"
WITH MY CAMPER HOOKED UP
1,350 lbs. Pin Weight (CAT Scale Certified)
Rear - 42-5/8"
Front - 40-1/8"
As you can see, it dropped the truck down 1-3/8". Before the install my truck would "squat" approximately 2-1/2" So, they made a big difference, an 1-1/8" difference. Before the install, the front was about (I never got a good measurement on that) 41".864295