Pop it into your hitch and tow - no assembly required! This ball mount's 4" rise is perfect if you're towing with a vehicle that has very little ground clearance. Includes 2 layers of rust protection and a black nickel-plated ball.
Features:
Specs:
Most ball mounts have just 1 layer of paint or powder coat to protect them from the outside world. Scratch this away after towing just a couple times, and the raw metal underneath will start to rust before you know it. Some folks take pride in that rusty, worn-in look. After all, rust is proof that you've had plenty of road-worn adventures.
But we prefer something that works hard and looks like it's barely broken a sweat. That's why we added a layer of e-coat underneath the matte black powder coat to give you an extra layer of rust protection. So while others might be driving around with a flaking, rusted-out hitch, yours will be looking great for the long haul.
Quick Tip: As for the hitch ball itself, if you really want to make sure that black nickel stays looking fresh for longer, we suggest greasing it up before you tow.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hello everybody, this is Jeff at etrailer.com. Today, we're gonna take a look at this etrailer pre-torqued two inch ball mount with the four inch rise for a 1-1-4 inch hitch receiver, has a 3,500 pound gross towing weight capacity. Now, this heavy duty ball mount will provide everything you need to embark on a towing journey with confidence. This ball mount right here will let you hook up your trailer to your tow vehicle. The shank right back here is what'll slide into your 1-1/4 inch hitch receiver. And then right up front here is the two inch diameter hitch ball, which will provide the connection point for your trailer's coupler.
What's nice about this, the ball is installed and it is pre-torqued to factory specifications. Does come with the included 1/2 inch pin and clip, which is designed to fit tightly in it to minimize rattle when you install this into your hitch receiver. It is a sturdy steel with rust-resistant finishes. The ball mount itself is a matte black powder coat over an e-coat on the ball mount. And the ball itself, if you look close, is a nice black nickel-plated hitch ball.
The matching black finish is also used on the pin and the clip. Application, as we mentioned, this fits into a 1-1/4 inch by 1-1/4 inch trailer hitch receiver, gross towing weight capacity is 3,500 pounds, tongue weight capacity of 350 pounds. Again, the ball diameter, which would be stamped on the top, is two inches. A couple measurements I wanna give you. The rise we said is four inches, and that rise is measured from the top of the shank to the top of the ball platform.
So just to show you, if we put a ruler on there, there's your four inch rise. The last measurement is gonna be the measurement from the center of this hitch pinhole to the center of the ball hole. So if we put a ruler on that, you can see that's gonna measure right at about 9-1/4 inches. But that should do it for the review on this etrailer pre-torqued two inch ball mount with the four inch rise for the 1-1/4 inch hitch receivers.
Average Customer Rating: 5.0 out of 5 stars (1 Customer Reviews)
Pop it into your hitch and tow - no assembly required! This ball mount's 4" rise is perfect if you're towing with a vehicle that has very little ground clearance. Includes 2 layers of rust protection and a black nickel-plated ball.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.