Replaces 1 connecting pin for your Meyer snow plow. Comparable to Meyer part number 11860.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Ellen: Hey, everyone! I'm Ellen here at etrailer.com, and we're going to be taking a quick look at the replacement pin for your Meyer Snow Plow. This is going to be a connecting pin to replace a broken or missing part on your snowplow and make sure that you can get back to work and not have to worry about things coming apart. It does have that larger pin within a secondary holding pin there. The handle is wrapped in this yellow rubber material to help give a little bit better visibility and also a little better grip.As far as the overall size lengthwise, it's pretty much right at 9 inches long going from the very end to the top of the handle. Going from the bottom of the pin to where it meets that handle, it's about 6 inches, just about. Our smaller piece is about 2 inches.
The handle width from the outside is about 5 inches wide. Going to the inside, it's about 3 3/4. The diameter of the larger pin is an inch. Then the smaller pin looks like it's about 3/8 of an inch, maybe 5/16. There's also a hole board through the larger pin, and it looks like that's about 1/4 of an inch in diameter as well.
This is made in the USA and that's about all there is to it for our look at the replacement connecting pin for your Meyer Snow Plow..
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.