Optronics 12V RV LED Puck Light - Surface Mount - 4-5/8" Long - White

Optronics RV Interior Lights - ILL45CB

Surface-mount puck light brightens up a closet, walkway, or kitchen countertop in your RV. Warm white LEDs are more energy efficient, last longer, and burn brighter than incandescents. The light turns on and off when wired to a switch.

Features:

• Puck light is perfect underneath a kitchen cabinet or inside a closet in your RV
• LED circuit board has surface-mount technology (SMT) that withstands shock, vibration, and heat
• Included energy-efficient, warm white LEDs last longer and burn brighter than incandescent bulbs
• Frosted polycarbonate plastic lens is less likely to shatter than a glass lens
• Sealed aluminum construction is waterproof
• Easy, bolt-on installation onto the surface of your ceiling or wall - hardware not included
  • Wires to a light switch inside your RV or camper - white for ground and black for power

Specs:

• Overall dimensions: 4-5/8" long x 4-5/8" wide x 3/4" deep
• Light face diameter: 4-1/2"
• Wiring length: 6"
• Voltage: 12V DC
• Power draw at 12.8V DC: 0.37 amps
• Light output:
  • Raw lumens: 300 lumens
  • Effective lumens: 260 lumens
• Number of LEDs: 42
• Lifetime warranty on LEDs

Need extra light on your kitchen counter for when you need to prep meals for the family? Or perhaps you need a light in the hallway so you can see where you're going when walking to the bathroom in the middle of the night? This puck light has warm white LEDs that give you a softer, accented light underneath a kitchen cabinet, in a closet, over a reading nook or chair, or in a walkway inside your RV or camper. And the sealed, aluminum housing and lens are waterproof so water won't leak in and damage the LEDs.

LEDs are more energy efficient, last longer, and burn brighter than lights with incandescent bulbs. You won't have to worry about replacing bulbs that have brittle filaments. And because LEDs draw minimal power, the light won't drain your battery, overload your circuits, or produce too much heat.

LED Circuit Board Has Surface-Mount Technology

Unlike other LED lights, this puck light has an LED circuit board with durable, surface-mount technology. This technology will better resist the shock and vibration that happens when you drive over rough roads. And it improves heat distribution, which means that you won't burn your fingers when you need to do maintenance.

Raw Lumens vs. Effective Lumens

Lumens are utilized to measure the actual amount of light that you can see and use from a light source. If you need a super bright light for a workspace, you will want to go with a light that has a higher lumen count. If you want a softer glow in an RV living space, you should go with a light that has a lower lumen count.

Light sources typically have 2 different kinds of lumens: raw and effective. Raw lumens represent the natural amount of light that a manufacturer says their light fixtures can produce. Effective lumens, on the other hand, represent the usable brightness of the entire light assembly, including the drive method or any lenses or reflectors.

Surface-Mount, Bolt-On Installation is Easy

This surface-mount puck light is incredibly easy to install as an upgrade or direct replacement of your existing light. To access the bolt holes, pop the lens off the housing. Then, using hardware (not included), bolt the light down onto the ceiling, wall, or cabinet before re-installing the lens. The light wires to a switch inside your RV and hooks up to ground (white wire) and power (black wire).

ILL45CB Optronics 12 Volt RV Puck LED Light - Surface Mount - 42 LEDs - White