Replacement Wheel Strap Assembly for Inno Fork Lock and Fork Lock III Roof Bike Racks

Video Transcript for Review of Inno Roof Bike Rack replacement strap - IN82FR

Hey everybody, Jared, at etrailer.com, today, we'll take a quick look at the replacement wheel strap assembly by Inno. Now, it's a direct replacement for the wheel strap assembly for your Inno Fork Mountain Roof bike rack; and this item will fit the Inno Fork Lock INXA391, and the Inno Fork Lock 3 INA391. We'll take a look at the item itself. We can see that this does look like the strap that you have there in place at this moment; and then I can pull on this and then it does strap on it the way it's supposed to. In order to release that, you push the suppression down, which is going to release the spring tension and remove that from that side. I can then push the spring tension to this side and I can remove the entire strap all the way through.

Taking a little bit closer look here, the ratcheting side, or where it was ratcheted down is a flexible plastic. It does have a smooth side on the inside and on the outside we do have these ratcheting sections here, that help hold and secure it into place. There is a part here that will end up allowing you to stop, so it doesn't feed all the way through back and forth, and loosen up over time. Put that aside, the bottom part here is going to be that plastic that sets on to your roof rack itself. Again, we have these sides here that are spring loaded that keep the ratchet in place.

We'll put this together, push that through, all the way through, holds it securely in place. I can then depress that side, put this through, and then you can hear the ratcheting section there, pull it tight and it's not going anywhere. Well, Inno is a quality brand and known to make fine products, and we carry many of these products here at etrailer.com. All right, well that was looking at a replacement wheel strap assembly by Inno. I'm Jared with etrailer.com.

You have a good one..