Custom Third Brake Light Camera for 7" Factory Monitor - Night Vision

GCH Automotive Accessories and Parts - GCH57FR

Custom bezel with camera mounts behind existing third brake light. Line up your fifth wheel or gooseneck trailer using your vehicle's factory monitor. Switch kit lets you toggle between views from your backup camera and third brake light camera.

Features:

• Custom bezel with camera mounts behind your third brake light so you can see into your truck bed
  • Works with your 7" factory monitor and IOR radio
  • Assists in connecting your fifth wheel or gooseneck trailer
  • Only functions while in reverse
• Camera manually adjusts up and down
  • Gives you a 160-degree viewing angle
• Rear assist marker lines generated by camera show distance from other objects
• 0 Lux night vision produces a quality picture in complete darkness without IR transmitters
• Switch kit allows you to toggle between truck bed camera and your factory backup camera
• Waterproof, aluminum camera resists dust and corrosion
  • IP69-rated to protect against dust and close-range, high-pressure spray downs
• Installation - uses your existing hardware
  • Drilling is required if you choose to mount the flip switch

Specs:

• Application:
  • 2019 - 2021 GMC Sierra 1500, 2500, 3500, 4500, and 6500
  • 2019 - 2021 Chevrolet Silverado 1500, 2500, 3500, 4500, 5500, and 6500
• Resolution: 620 lines
• Voltage: 12V - 24V DC
• Wiring harness: 24' long
• 3-Year limited warranty

Note: Most models have a silver sticker inside the glove box that displays your radio type.

Rear Assist Lines

The rear assist lines generated by the system's camera make connecting your fifth wheel camper or gooseneck trailer a one-person job. The lines appear on your 7" factory monitor and show the distance from other objects, allowing you to accurately line up your connection point when hooking up your camper or trailer.

0 Lux Night Vision

0 Lux night vision produces a quality picture and gives you the flexibility you need when hooking up your camper or trailer. You can line up your connection point in low-light conditions at dusk, or in complete darkness at night without the aid of IR transmitters.

Switch Kit

The switch kit adds a new dimension to your current setup, allowing you to toggle between views from your truck bed camera and factory backup camera with the flip of a switch. The integrated flip switch can be mounted inside of your truck to give you a clean OEM look and easy access.

Simple Installation

Simply unscrew and unplug your factory third brake light. Once removed, set your new custom bezel with camera in place. Feed the 6' camera wire through the opening into your truck and re-install your factory third brake light in front of the custom bezel.

Next, connect your 6' camera wire to the 18' wiring harness. This combined 24' wire will extend through your head liner or door sill panel along the edge of the floor, up to the front of your truck, and connect with the included ground and power wiring harness. The power wire will run to your truck's battery.

Included wiring harness allows for simple plug and play installation with your vehicle's module. The integrated power wire for the flip switch will run to 12V accessory power.

19GMBRK360-K1 Truck Bed Camera for 7" Factory Monitor - Night Vision - Switch Kit