Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today we're going to take a look at the 150 amp panel mount circuit breaker with the manual push-button trip reset. Now this circuit breaker's ideal for switch and power distribution panels. It is designed to protect auxiliary and accessory circuits on dump hoists, plows, spreaders, lift gates and cranes. It does have this manual push to trip reset here than when you push it, it will give you a quick break in your connection when you need it.And then to reset your connection you just push that right back into place. This is a waterproof design. It's all in a black plastic box.
Now this one is a panel mount so it does have the two 1/4 inch mounting holes on it. On the back it has the two 1/4 inch by 28 threaded stainless steel studs with the stainless steel nuts for a good connection. Trip current on this is 150 amps. Maximum volts is 42 volts DC.And a few measurements on this. The overall width, it's going be right at 1 15/16 inch.
Over height is going to be right at 2 15/16 inch. And the total depth including the button sticking out there, is right at 2 1/16 inch deep. But that should do it for the review on the 150 amp panel mount circuit breaker with the manual push-button trip reset.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.