Customers compare TSS-106-40 to these similar products
Info for these parts were:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
The Timbren Trailer Suspension Enhancement System for Underslung Axles #T92MR is 5-1/4" tall. Timbren recommends The spring be in constant contact with the frame at all times. So ideally you will want exactly 5-1/4" from your axle tube to…
view full answer...According to my research your 2023 Grand Design XLS 23LDE should have tandem 3,500 lb axles in an "underslung" (leaf springs below the axles) configuration. This means you need two of the following SumoSprings kit: - SumoSprings Trailer…
view full answer...While we do not have a video showing the installation of the line relocation kit that comes with the SumoSprings Trailer Helper Springs #TSS-107-40, I have linked a video below that shows an example of when one will be needed and explains what the…
view full answer...It won't because the grove in the leg is different enough that they aren't compatible, however I have another option that will. It is the Replacement Drop Leg for Bulldog Round Trailer Jack or Powered Drive Camper Jack item #BD500190. This is…
view full answer...The instructions for the SumoSprings kit part #TSS-106-40 do not specify whether they should install in front of or behind the rear axle but I would recommend in front of the axle since most shock is going to be first on the front portion of the axle…
view full answer...When installing the Sumo Trailer Springs #TSS-107-40, is very important as the Trailer SumoSprings provide the maximum level of vibration reduction and damping with the 1/4”-1/2” preload. That being said, the measurement is extremely close and after…
view full answer...The SumoSprings Trailer Helper Springs item #SS26MV require 5-5/16" - 6-1/2" of clearance. This is from the top of the spring plate to the bottom of your trailer. Since you are right at 5" you should be ok once you jack your trailer up…
view full answer...Based on what you are saying and your photos, it apprears you have springs that are double eye springs. The springs will need to be based on the load of your trailer. The axle capacity may be difficult to know as you said it appears to be custom. I…
view full answer...The SumoSprings Trailer Helper Springs w/ Line Relocation Bracket #TSS-107-40 will work with 4,400 lb axles. It will fit your trailer so long as the axle is an overslung axle, which means the leaf spring will be over the axle. If you take a look at…
view full answer...I forwarded your photo to the folks at Sumo Springs, and was told that as long as the spring mounts so its level and doesn't rock back and forth, you'll be just fine. From what's shown in your photo, everything looks like it's nice…
view full answer...You'd want to install the SumoSprings Trailer Helper Springs #TSS-106-40 on the front side of your axle.
view full answer...The correct SumoSprings Trailer Helper Springs for overslung axles (axle under leaf springs) is part #TSS-107-40. The springs will be pre-loaded upon installation therefore the space you have between the frame is spring loaded will be less than the…
view full answer...