Expert Answers about Keystone

• Is There a Tool Needed to Install Rubber Top Lip Wiper Seal for RV Slide Out - Press On
• I do have an option for you but there isn't really a specific tool needed for the Rubber Top Lip Wiper Seal for RV Slide Out part # SR23VR. It features a simple press-on installation so there will be no tool needed for this. That said, I could see how removal would be a bit more challenging, if you just simply pulled up on the top of the seal you would likely tear it so it might help to use a pry tool and lift up at the bottom of the seal where it's pressed onto the flange. In which case,...
  view full answer...


• Recommended 15 Inch Replacement for 205/75-14 Tire on Travel Trailer
• A 205/75-15 tire is what I'd recommend. The tire would be 1 inch taller in diameter which would raise the ride height by 1/2 inch, and the tire would be about the same width as your existing tire, which is 8 inches. . If a Load Range D tire with a 2150 lb per tire/4300 lb per axle capacity would work for you, I'd recommend the Taskmaster Provider tire, part # TR20515D. You can see a product description video by using the provided link.
  view full answer...


• How to Tell if Spring is out of Alignment For Trailair Air Ride 5th Wheel Pin Box LC155943
• Thank you very much for your purchase from etrailer of the Trailair Air Ride 5th Wheel Pin Box # LC155943. The pin box has a keyway where the spring bolt sits that you slide in where the air spring rests; it is hard to see the whole thing due to it being black, but I added a photo which shows where it is. You move it by hand, back and forth, with the spring fully deflated. If the air bag was tilted, this is indeed an indication the alignment may not have been fully in the hole.
  view full answer...


• Best Timbren Suspension Enhancement for a 2020 Keystone Cougar 34TSB Travel Trailer
• The Timbren Trailer Suspension Enhancement System # T63MR you're looking at has a weight capacity of 8,600 lbs and since your 2020 Keystone Cougar Half-Ton 34TSB Travel Trailer has a base (unloaded) weight of 8,563 lbs you'll only get help from these Timbrens when you don't have anything loaded up in the trailer. Since this is the case you'll be better off with a Timbren set that has a higher-rated capacity, like the 10K Timbren Trailer Suspension Enhancement System with Under Steel Frame...
  view full answer...


• 3-Way Light Switch Needed For A 2011 Keystone Hornet Travel Trailer
• For your 2011 Keystone Hornet, you can use the Single Rocker Switch # 37212635 in white, or # 37212625 in black to in two different locations to create a 3-way switch that can be controlled in separate locations.
  view full answer...


• Recommended RV Cover For A 2006 Keystone Raptor Toy Hauler 5th Wheel
• The specs I'm seeing for your 2006 Keystone Raptor Toy Hauler 5th Wheel show 37'-7" in length so you'll want to go one size up from the ADCO AquaShed RV Cover # 290-52256 to the Adco SFS AquaShed RV Cover for 5th Wheel Toy Hauler - Up to 40' Long - Gray Item # 290-52257. You'll want to have a little extra slack to ensure you can fully cover your Toy Hauler and you'll be able to tighten up the excess with the straps and buckles.
  view full answer...


• Is Everchill Wine Cooler Really Better for RV Applications than Standard Fridge
• The Everchill Wine Cooler # 324-000115 is more or less a standard wine cooler but it was made with the tighter space limitations that RVs have in mind as well as has a bit of a stronger magnet in the door which helps keep it closed.
  view full answer...


• How To Wire In 4-Wire Furrion Side Marker Cameras With Only Two Running Light Wires
• On the Furrion Vision S Wireless RV Observation Camera System w/ Side Marker Light Cameras # FCE48TASL-05 the Red (V+ Camera) goes to the positive wire of the running light circuit, the Black (GND) to the ground, the Yellow (Trigger) to the left/right turn signal (only available for LED versions), and the Brown (V+ Lamp) to the positive wire of the running light. If you had a turn signal circuit you would need to wire the Yellow wire to that, but since you don't you can just cap the wire...
  view full answer...


• Tankless Hot Water Heater for a 2018 Keystone Hideout
• While we likely have an option for you, there is no document or anything that tells us what size cutout or style of water heater you currently have. I am assuming when you say "instant" you mean tankless hot water heater. The Fogatti RV Tankless Water Heater # LSB44FR is a great option that uses gas to heat and fits a cutout that is 13" wide x 13" tall x 17-3/4" deep. You would also need the Camco RV Water Heater Temperature and Pressure Relief Valve # CAM10423 for insallation. If you...
  view full answer...


• Replacement Suspension Recommendation for Tandem Axle 14K Trailer
• I really like the Timbren Silent Ride systems like part # TSR14KT01 that is rated for 3" axles and 14,000 lbs. This gets rid of the traditional leaf spring setup and gives you pivoting arms and Double Aeon rubber springs for a better ride quality. The mounting bracket bolts to your trailer frame and is for 33" wheelbase applications. If this matches your Keystone I'd say go for it, otherwise let me know your wheelbase (center axle to center axle) and I can see if we have one that will...
  view full answer...


• Can I Replace My Dometic AC Unit With A Furrion 15000 BTU Air Conditioner
• Nice question, lets go see what we can find out. **Furrion Chill Replacement RV Air Conditioner for Coleman Setup - 15,000 Btu - White # FR42PV. The Furrion Chill Replacement can indeed replace your old dometic unit and it comes with the wire adapter to do so. This lets you keep everything under the roof the same. We do not have plenums by themselves, they only come included with certain units. If you need one for any reason I would recommend the Furrion system listed below: *Furrion...
  view full answer...


• Can Bumper be Cut Off Keystone Montana High Country to Install Mount-N-Lock AddaBumper
• The Mount-N-Lock bumper extension part # MO24VR was designed for situations like yours. You can cut off your bumper and use these to attach to the frame to extend out far enough to install the Mount-n-Lock Heavy-Haul'r Replacement RV Bumper # MNT63VR. While I am not totally sure what you mean by surmount tube on the frame you would want to cut everything off smooth so that the extension bracket can attach properly.
  view full answer...


• Replacement 24" Wide, 1-Step RV Step For a 2018 Keystone ROV Travel Trailer
• I saw that you were looking at the Flexco Manual Pull-Out Steps for RVs # SMFP-2100. We do not have any manual pull out steps in the 24", 1-step configuration you are needing. We do have some electric steps that meet those requirements though. Steps like the Kwikee Electric RV Step Complete Assembly # LC3723383. The # LC3723383 needs mounting space of 25-1/2" wide and 11-5/8" deep. If you have that, these steps will work for you. There is no database that tells me what you have on your...
  view full answer...


• Recommended 7-Way Connector for a 2023 Ford Bronco w/ Incandescent Tail Lights
• To install a 7-Way harness on your 2023 Ford Bronco you will need two separate wiring harnesses because they don't make just one that'll do the job. The first harness you'll need is the Curt T-Connector Vehicle Wiring Harness item # C87BR. This custom-fit T-connector plugs into your Bronco's wiring harness, which is located behind the incandescent tail lights. This will provide you with a 4-flat connector. The second harness you will need is the Universal Installation Kit for Trailer...
  view full answer...


• Recommended Fold Down Rv Steps For A 2019 Keystone Passport 171 EXP
• Based on the measurements you provided of your 2019 Keystone Passport 171 EXP you'll need the MORryde StepAbove RV Steps for 23-3/4" to 26-1/4" Wide Doorways # MR26RR. These steps have an entry height range of 25" - 29" and door width range of 23-3/4" - 26-1/4". I've attached a short video below where Aiden will walk you through the installation process.
  view full answer...


• Can The etrailer Lead Spring # e54SR Replace Springs With A 25-12" Eye-To-Eye Measurement
• Since leaf springs tend to flatten out over time the original eye to eye measurement was probably closer to 25-1/4" or 25-1/8" so the 4-Leaf Double-Eye Spring for 3,500-lb Trailer Axles # e54SR would be an acceptable replacement. The shackle straps on the equalizer should allow you to make up the difference. Now would be a good time to also check your shackle straps and bolts for any damage and replace as needed. If you need help finding the correct replacements or want to switch to wet...
  view full answer...


• Correct Replacement Shroud for a Dometic Duo Therm RV AC
• The correct replacement cover for your Dometic Duo Therm, model 57915.351 is the Replacement RV Air Conditioner Cover for Dometic Duo-Therm # DMC69FR. This cover measures 40-1/2" long, 29" wide, and 7" tall.
  view full answer...


• Replacement Brake Assemblies for 2008 Cougar 245RKS 5th Wheel with 12 inch by 2 inch Assemblies
• Sounds like maybe someone swapped your axles to a higher capacity which is why your brake assemblies sound like they are rated higher than what you found on the trailer info. Based on what you have the best option is the etrailer brake kit part # AKEBRK-7-SA as these are going to fit and work well plus are self-adjusting so you don't have to worry about ever needing to adjust them. I attached an install video for this for you to check out as well.
  view full answer...


• Slide Out Topper for 117-1/2 inch Flange Width on RV
• Thanks for the flange width of your slide out! Based on knowing that dimension is 117-1/2 inches the correct slide out you need is the part # LCV000182037. This is the 10-1/2 foot long length.
  view full answer...


• USA Made Bearing Kit For An AL-KO 4,400 lb Axle
• The ALKO 4,400 lb axles use the same bearing sizes as the standard 3,500 lb alxes. If you want USA made bearings, I recommend the Bearing Kit # TMK52VR. This kit comes with the Timken brand bearings which are all made here in the USA.
  view full answer...