Yakima EXO SwingBase with DoubleUp 2 Bike Rack Review Video

From end to end, the extendable arm measures 30-5/16 inches for the Kuat Pivot 2 Swing Away Hitch Extender for Bike Racks - 2" Hitches - Driver's Side #PVD20B.

Yes, you can use the Napier 82000 suv tent with the Yakima EXO Swing Away Camp Kitchen and Enclosed Cargo Carrier item #Y86AV. You will just need to mount your tent off center towards the drivers side so you have enough room for the swing arm to…

The distance from the hitch pin hole of the Saris Swing Away Hitch Extender part #SAR36VR to the other hitch pin hole is 13-1/2 inches.

If you are not transporting all 3 of the step-through bikes at the same time then you could use the HoldUp, #Y02443, which has a 2 bike capacity. Otherwise you would use the 4-bike version, #Y02443-2. As long as the bikes do not have fenders on the…

I got some information from Yakima and included a diagram of the EXO SwingBase #Y34VR, which is the base part for the EXO SwingBase 2 Tier #Y82VR. Though the measurement from the pin hole to the closest edge of the carrier is not included in said…

The top of the Curt Trailer Hitch Mounted Spare Tire Carrier #c31006 will sit 9-1/2" out and 24" up from the center of the hitch pin hole on your 2004 Toyota Sienna. I don't have a way to verify whether this gives you enough clearance…

From the center of the hitch pin hole to the upright portion of the Saris swinging hitch adapter #SAR36VR the measurement is 9 inches so this would easily clear past your spare since it is 7-3/4 inches out past the rear hitch pin.

The Kuat Pivot 2 Swing Away Hitch Extender for Bike Racks - 2" Hitches - Passenger's Side #PVP20B is a more common fit because it swings to the passenger side instead of the driver's side like #PVD20B you asked from. To get the…

I checked with Konig and tire chains TH2004705265 are rated for 50 kilometers per hour which is the same as 31 miles per hour. On a 4x4 vehicle it is better to put the chains on the main drive wheels which on a 4x4 is the rear set.

The Yakima Replacement Hitch Bolt and Clip for Yakima HoldUp Hitch Mounted Bike Carrier, part #Y8890200, is a 5/8 inch bolt. The size wrench you would use to install or remove this bolt is 15/16 inch.

It should but you'll want to take a measurement from the hitch pin hole on your 2022 Ford Bronco to confirm. The closest part of the RockyMounts BackStage Bike Rack item #RKY10002 is 9-1/2" from the hitch pin hole. It looks like your base…

The typical tire should run about 158 degrees (Farenheidt) once you get going down the road, but this can vary greatly depending on the weight of the trailer, how fast you're traveling, and also driving habits. So while 158 is probably…