Tow-Rax Removable Wheel Chock Review TWSPWC Video

The Transcom #TCM 21344 TB cross references to the 10-10 seal we offer, part #RG06-090. The seal has a 2.125 inch ID and a 3.376 OD. It's compatible with a 25580 inner bearing.

The C-Channel for Enclosed Trailer #362213-955 has an opening of 1.027". I have included an image below with all the dimensions for this item.

B&W makes their Biker Bar motorcycle transport systems, such as #BWMC2301, just for hogs but we do have other setups for cruiser and touring motorcycle transport that are general-purpose products. You can see all of these wheel shock products…

From what I could find, the Harbor Freight trailers do say not to exceed 45 miles per hour in the owners manual. That being said, the tires they use are not rated very high and may be the limiting factor. The trailer you have looks to use a 5 on 4…

Since tie down straps like #EM34410 are bearing the vast majority of the weight of the bike, attaching the wheel chock using the #TWPH2770 hardware kit is perfectly acceptable. The chock is merely helping hold the front wheel in place, the tie downs…

Actually when you use the Fulton Economy Spare Tire Carrier #FETCLB0201 that you referenced you do not use nuts to secure the U-bolt. Each of the brackets are threaded and basically become the nuts that hold the tire to the U-bolt. You will just need…

I was able to verify that the weight capacity for the Aluminum Car Hauler Ramp Set #288-07503 that you referenced is indeed 6,000 pounds (not kilograms) for the pair and 3,000 pounds per panel. The recommended maximum height of 16 inches is simply…

Your 2013 Ford F-150 must have come with the factory 4-Way connector. Since the harness for that connector uses a square plug and not the round plug, a simple plug and play 7-Way is not available. You will have to partially hardwire in a 7-Way using…

Great news! I found that the width of your 2016 Indian Vintage's front tire is just over 5 inches. This will work great with the removable Tow-Rax Wheel Chocks. Depending on what type of trailer floor you have we off the wood screws with chock in…

The Tow-Rax Removable Wheel Chock #TWSPWC3BT can be installed on metal surfaces using the included hardware kit. You will need a drill with a 9/16-inch bit for metal floors as well as a 3/16-inch bit. You will also need 5/16-inch and 3/16-inch Allen…

If you went with the Tow Rax Wheel Chock part #TWSPWC3BT you could use replacement hardware part #TWPH2770 and basically be able to mount a single chock in several trailers. The chock easily removes off of the hardware by sliding backwards and…

The Tow Rax Wheel Chocke part #TWSPWC3BT does not have a weight capacity or a bike size limit. It is dependent on how it is mounted. For example if secured to a metal or solid wood floor using the proper fasteners for that material then it could…