Thule Apex XT 2 Bike Rack Review Video

The etrailer Trailer Hitch Receiver part #e98902 which is a fit for a 2013 Mazda CX-5 weighs around 34 lbs.

Congrats on your new bike rack! While both Class I and Class II hitches have the same 1 1/4 inch opening, they have different towing and weight capacities. Manufacturers sometimes build a stopper inside the Class I hitch receiver to prevent Class…

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

I have a solution for you. Here at etrailer, we highly discourage using a wheel-mount bike rack like the Thule T2 Pro XTR Bike Rack for 2 Bikes - 2" Hitches - Wheel Mount #TH83JV when using bikes with fenders. The wheel mounts increase the…

Since you have the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" Item #C13200 on your 2017 Toyota Highlander you aren't limited to a certain type of rack because your hitch is a class III hitch receiver. Both the Thule Apex XT 4…

Although we don't offer a dual hitch adapter for a 1-1/4 inch hitch like the #36284 you'd looked at, I do have a solution that could work for you, assuming that your bike rack and bikes weigh less than 100 lbs and the trailer's tongue…

If you installed the Draw Tite hitch part #24768 on your 2007 Acura TSX the Thule Apex 2 XT #TH9024XT would fit and work great!

If you are needing to use a 2 inch accessory such as a ball mount or bike rack with a 1-1/4 inch receiver on your vehicle you will need to use an adapter between the two. We have a nice selection of 1-1/4 inch to 2 inch adapters available, such as…

The Thule Apex #TH9027XT has similar dimensions to the Yakima Full Swing #Y02465 and will come in contact with your spare tire if you try to swing the back trunk door open. I attached a picture where we tried this bike rack with a Jeep with a spare…

There is just a bit of fascia trimming required on your 2019 Subaru Legacy in order to install the EcoHitch Hidden Trailer Hitch Receiver #306-X7384. What that means is you'll simply snip off part of the bumper fascia in order to give the…

For your 2019 Subaru Legacy, I recommend the etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2" #e99YR. This hitch comes with the easiest installation process out of any hitch we carry for your vehicle. It only…

The original Thule Helium was made of ultra-lightweight aluminum, featured sliding anti-sway T3 cradles with rubber straps. The cradle arms were spaced 12 inches apart (outside to outside). The rack could fold and tilt. It also featured an integrated…