Hughes 30 Amp Portable Power Watchdog Surge Protector Review Video

Hey Beatrice, To find the right fit for your trailer's suspension you'll need to take a quick measurement of your current shackle straps. You'll need to measure from the center of one bolt hole to the center of the other bolt…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

Thanks for the picture of your wheel and valve stem setup. I'd recommend 135 degree valve extenders like the part #WM8029135 as this will put the valve stem at a better angle than a 180 degree kit. These will work great with your current wheel…

You can absolutely go from your current 3-1/4 inch shackle straps to the 3-1/8 inch shackle straps of the MORryde upgrade kit for tandem axle trailers. That 1/8 inch difference in length will not be a factor for your ride or the fit; the correct kit…

The usable portion of the longer wet bolts that comes with the MORryde kit part #MR76ZR are designed to be used with a 1-3/4 inch wide leaf spring but the section of the bolt you are asking about is 2-1/4 inches wide. This is the smooth part of the…

The etrailer #e98ZR is comparable to the Curt #c31006 you'd mentioned, but I'd stick with the etrailer version. The reason for this is the etrailer version comes with a hitch aligner so that the hitch pin hole always aligns perfectly, and it…

I recommend starting with the Roadmaster Rear Anti-Sway Bar, #RM-1139-147. This will reduce side-to-side movement for a noticeable improvement in your vehicle's stability and reduced body roll. For the front, I recommend the Timbren Front…

In order to confirm fit of the etrailer Hitch Mounted Spare Tire Carrier part #e98ZR with your setup you'll need to know the bolt pattern of your wheel. This carrier will work with any size wheel with a bolt pattern of 6 on 5-1/2" or…

I would start by checking for a missing relay and/or missing/blown fuse. I found the 2011 Ford F-150 owner's manual online with the following information. The fuse and relay that you'll need to check is located in the power distribution box.…

According to CIPA, the #CM11800 will fit the mirrors on a 2012 Ford F150, except for manual mirrors with no turn signal or STX model trucks. If you refer to the photo I edited for you, you can see the OE mirror that the CIPA mirror will fit over.

There could be a couple of different issues. First, make sure that the wire that leads from the trailer side 7-Way to the trailer brakes is located in the 7:00 position if looking at the face of the connector. If not, then that could be why the…

The #RED44FR is the 331-EBRH-ACCV3, which is the 3rd version of the Redarc Tow Pro Elite controller that was originally only available in Australia; the #331-EBRH-ACCV2 is the 2nd version and has been phased out. They're really mostly the same…