Dust Cap Driver Tool for TruRyde Lubed Dust Cap # DC250L-DCRP

Question

Question:

I need the Dust Cap Driver Tool that works with Dust Cap .................2-1/2inch Lubed Dust Cap and Rubber Plug - 2.45inch x 1.52inch x 1.18inch - Qty 1 - DC250L-DCRP

asked by: Jim

0

Expert Reply:

For the TruRyde Lubed Dust Cap and Rubber Plug # DC250L-DCRP referenced in your question, which has dimensions of 2.45 inch x 1.52 inch x 1.18 inch, you can use the Redline Dust Cap Driver Tool - Medium # 290-992.

This can be used for installation, removal and servicing trailer hubs without denting the dust caps. I have attached a short video demonstration on this product for you to check out.

expert reply by: Chris R

0

Answer 1

Pete, yes the Snap-In Plug for Lionshead Trailer Wheel Center Cap #LHSI60C are definitely not brittle and are better made than most. This is still made of plastic, has a chrome finish, and will work with 15" to 16" diameter wheels with a 6…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The attachment bolts for a 5-bolt brake assembly like the part #AKEBRK-6R should be torqued to 30-50 foot/lbs. If you don't have a torque wrench handy, if you tighten the bolts until the lock washers flatten out, you'll be pretty darn close…

view full answer...

Answer 4

The Replacement Lippert Correct Track Weld-On Axle Hanger, part #LC303918, has raised edges to fit the octagon cam. Since this hanger cannot sit flush against the axle the Correct Track Trailer Alignment and Lift Kit - Tandem Axle, part #RR23QX, is…

view full answer...

Answer 5

Hey Jon, Yes, the Advent Air Low Profile RV Air Conditioner #ADV79FR is compatible with the Air Distribution Box #ACDB. This would have the controls on the air distribution box instead of a wall mounted thermostat. We don't currently have any…

view full answer...

Answer 6

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 7

In order to verify the spindle dimensions so that you can pick out the correct hub/drum you have to get exact dimensions. For that you need to use a digital caliper like part #PTW80157. For how old your trailer is this is especially important as the…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

I spoke with my contact at Trailair and from your serial number we were able to determine that your trailer came with a 1621 HD pin box which is a long pin box style. I was unable to obtain the exact part number for your Trailair pin box but from the…

view full answer...

Dust Cap Driver Tool for TruRyde Lubed Dust Cap # DC250L-DCRP

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching