EcoHitch Hidden Trailer Hitch Installation - 2019 Subaru Outback Wagon Video

Yes, the mounting bolt patterns are similar between the EcoHitch #306-X7266 for a 2018 Subaru Outback Wagon and the EcoHitch #306-X7601. With that being said, the hitch receiver for the #306-X7266 sits about 1/4" to 3/8" lower than…

The Draw-Tite Max-Frame Trailer Hitch Receiver part #76227 which is a fit for a 2010-2019 Subaru Outback will install via eight total 10mm nuts which are actually reused as they are the factory fasteners for the bumper beam. The most up to date…

The best trailer hitch for your 2019 Subaru Outback Limited is the Curt #C13206 because it has the best bumper clearance among hitches that fit your car; this hitch is a fit for both the 2.5i Limited and 3.6R Limited. This Class III, 2" trailer…

To install the Draw-Tite Max-Frame Trailer Hitch Receiver #76227 on your 2018 Subaru Outback you only need a torque wrench capable of more than 50 ft. lbs, which is going to be most of them. I recommend getting one that has a wider range for other…

I definitely understand being a bit overwhelmed by the amount of options in front of you, however I can definitely help with differentiating the trailer hitches for your 2019 Subaru Outback Wagon along with explaining my personal recommendation,…

The foam piece of the bumper on your 2019 Subaru Outback Wagon does not get re-installed when you are putting on the EcoHitch Hidden Trailer Hitch Receiver #306-X7601. It will interfere with the fitment and in the instructions does specify to remove…

The Draw-Tite Hidden Hitch and Stealth Hitches fits for your 2015 Subaru Outback Wagon will allow you to carry the Kuat NV 2.0 bike rack WITHOUT a stabilizing strap. Draw-Tite Hidden Hitch - #DT38GR Stealth Hitches - #391SUOB15 Kuat NV 2.0 - #NV22G I…

The EcoHitch trailer hitch, part #306-X7601, does sit underneath the rear bumper so it reduces the ground clearance at the bumper for sure. It installs right up to the fascia on a Subaru Outback Wagon so if you measure from the underside on one down…

You'd have to check with Subaru to see what they recommend for the sensors you have that are falling out. I wasn't able to find any info on that online and we've not seen that issue. For trailer wiring though we have the T-One kit part…

In order to pick out the correct hub assembly for a trailer you are going to need know a few key pieces of information. I wish there was a way to find out what you need based solely on trailer info that you gave, but that's not something…

I've linked an install video of the EcoHitch, part #306-X7601, being installed on a 2016 Subaru Outback for you. The tools you need are: Phillips and flat head screwdrivers Ratchet with 10 mm socket Trim Remover, part #ALL648544 Mallet Utility…

The EcoHitch Hidden Trailer Hitch Receiver - Custom Fit - Class III - 2" #306-X7216 will be slightly different than the Draw-Tite #76182 you mentioned. I've attached a photo of the torque specs from the EcoHitch you mentioned. The attached…