Trailer Hitch Installation - 2015 Hyundai Genesis - Curt Video

I spoke with my contact at Curt, and he said that the Curt Trailer Hitch #C12086 is a fit for the 2015 Hyundai Genesis AWD. The trailer hitch's warranty from Curt requires that stabilization straps #18050 be used when hauling all non-trailer…

The Saris Freedom Bike Rack for 2 Bikes - 1-1/4" and 2" Hitches #SA4412B will work well with your Electric Bike Company Model Y. It has a weight capacity of 60lbs per bike; according to my research your bike weighs about 56lbs, so there…

The Curt Hitch part #C12086 that you referenced has been confirmed as a fit for your 2015 Hyundai Genesis Sedan so I would recommend it for you. The install video that I attached is for a 2009 but the process will be the exact same for your 2015.

If your 2015 Hyundai Genesis is a sedan, then the Curt Trailer Hitch, part #C12086 will work great for you. Per a note from Curt, all non-trailer loads - bike racks, cargo carriers and so forth - should be supported with stabilizing straps like part…

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…