Trailer Hitch Installation - 2012 Honda Odyssey - Draw-Tite 75270 Video

I looked up the instructions for the Draw-Tite hitch, part #75270, and the torque specification for the 6 M12 bolts is 68 Lb.-Ft. I have added a link to the instructions below so that you can review them. The torque rating is just above the small…

We don't post the torque specs for the hitches we carry as they are subject to change by the manufacturer and since we link the install instructions for all of the hitches directly from the manufacturer if they were to ever change our linked…

For the Draw-Tite trailer hitch, #75270, or any of the trailer hitches we carry, the torque specifications can be found after the last step in the installation instructions that are linked on the page. Because the design of a hitch could change or…

From what little I was able to learn about the VelociRAX 5 bike rack on their website, the rack is compatible with a 2 inch hitch that has a tongue weight capacity of at least 500 lbs, and the Draw-Tite #75270 Class III hitch meets both those…

For a hitch with a high enough tongue weight capacity you will need the Draw-Tite Max-Frame Trailer Hitch Receiver #75270. Although the #e98862 does have a max tongue weight of 500 lbs with weight distribution, this would require a weight…

I spoke with Hidden Hitch and you are correct:Hidden Hitch part #70737 was obsoleted in 2009 and replaced with Draw-Tite part #75270. Draw-Tite part #75270 is form/fit/functionally the same as part #70737. There are a few aesthetic differences…

For your 2022 that is NOT a hybrid :) we have the Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4" #C11525 as a confirmed fit. This hitch has a weight capacity for the tongue and trailer: 200 and 2,000 lbs. respectively. It has a nice…

For your 2016 Honda Odyssey, I recommend the Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2" #75270. This hitch will not require any additional parts to install. It will come with all the hardware, so you just need to…

The Draw-Tite Class III hitch you referred to, part #75270 uses Class 8.8 M12x35mm bolts with a 1.25 thread pitch. The bolts would fasten to the weld nuts that are welded to the inside of the frame members. When you install the hitch, take some time…

Most ball mounts, like the Draw-Tite #2753 can be used in both a rise (upside down) and drop (standard) position. I'm not seeing any Curt ball mount with a part number 45836, but as I mentioned, most ball mounts are designed to be used either…

I would be happy to set up your 2016 Honda Odyssey to tow your Casita Travel Trailer. You're going to need a hitch, ball mount, a couple of wiring harnesses, brake controller, and the requested transmission cooler. Unless your van already has a…

In order to install the Draw-Tite Max-Frame Trailer Hitch Receiver part #76025 on a 2014 Honda Odyssey you"ll need to trim the fascia in the center to allow the receiver tube opening to pass through and above the tail pipe. The reason you must…