Roadmaster Car Side Tow Bar Quick Disconnects Installation - 2014 Ford Focus Video

Because of the design of the EZ5 base plates, #RM-521567-5, for your 2014 Honda CR-V, there isn't a protective device that mounts on the vehicle or between the vehicle and the motorhome that will work. What you can do is use something like Rack…

Yes, the LED lights on your truck will not affect the Roadmaster Universal Hy-Power Diode Wiring Kit #RM-154. You will be able to use this kit with those lights and it will work well. I have added a link to a video review below for you to take a look…

Flat towing your Jeep Wrangler behind your Class A motor home will require the tow bar, a lighting/wiring kit, safety chains, base plates and a supplemental braking system. The linked article will give you background on each of these. The Quick…

There are a number of replacement parts available for your Falcon All Terrain Tow Bar #RM-522. Without knowing the specific parts you are seeking, I'll list what we have available for you to take a look at. - Replacement Inner Arm #910021-65 -…

The tow bar I recommend for the Blue Ox Base Plate Kit part #BX1987 on a 2009 Smart Fortwo is the Blue Ox Alpha 2 Non-Binding Tow Bar part #BX7380 which fits a tab spacing of 16-36". This will work great with your 17" tab spacing on the…

To replace the latch lever on your discontinued Roadmaster Sterling TowBar, item #RM-576, you will need to use the item #RM-750600, and then put the serial number, that is on your tow bar, in the box provided on that product page.

The Replacement Handles for Roadmaster Sterling All Terrain Tow Bar #RM-910003-35 are held in place with pins. These should be reused from the original handles. I included a picture from the instructions for the Sterling tow bar #RM-576 that shows…

We do carry replacement handles for your older Roadmaster Sterling tow bar as part #RM-910003-35. If you need any hardware for the handles as well then that would be found in the Spring Kit #RM910652. I confirmed all of this with my contact at…

Once installed, the arms will be 28-1/2 inches apart, measured center to center as shown in the provided photo..

The outer trim pieces on the Jensen RV Stereo #JWM60A (which is the same as your JWM62A model) are simply pressed into place and secured with the integrated tabs. To remove them you will just locate the small notch on the side of the trim (see…

If you already have the diodes installed, all you have to do is it connect the motor home to the Jeep Wrangler. The diode kit probably came with a 4-Way flat trailer connector that should be at the front of the vehicle. In a perfect world, the motor…

After looking up the wiring diagrams for your old RV Stereo AWM970 and your new Jensen RV Stereo #JWM60A (Jensen part number JWM62A) you new stereo should actually have 3 more wires, not less wires. The AWM970 had two connectors, a 12 pin and a 4 pin…