Redarc Tow-Pro Liberty Brake Controller Installation - 2020 Ram 1500 Video

Yes, the Redarc Tow-Pro Liberty Brake Controller part #RED24FR is compatible with electric over hydraulic surge brake actuators such as the ones from Hydrastar. It works with all Hydrastar actuators.

Factory brake controllers seem to unfortunately be very temperamental and usually quite a bit more expensive that an aftermarket brake controller so I have to recommend going with an aftermarket option. Luckily there is a brake controller port so…

To install the excellent Tekonsha Prodigy P2 Trailer Brake Controller #90885 on your 2019 Ram 1500 you just need the Plug-In Wiring Adapter #3024-P. The factory brake controller port should be located underneath the dash, above and in front of the…

There are 4 screws on the bottom of the bottom cover holding it to the top. And if you remove the cap on the very top of jack #LC285318 you will see 2 more screws. With all the screws removed you should have no problem with the cover. These very…

Thanks for passing that on! I attached the install video for the #C56040 on the 23 Outback you mentioned as well.

The L-brackets of the Reese weight distribution system #RE44FR need to install between 24.5 and 27.5 inches from the hitch ball center. I attached a picture that I took from the instructions that shows this. The range gives you a bit of flexibility…

I would be happy to recommend a ball mount for your Ram 1500 4WD with air bags installed, but the correct ball mount is really going to come down to how much of a rise/drop you need to tow your trailer level. To determine the rise/drop you need you…

This will depend on the hitch used and the height of the trailer coupler. You want the trailer to be as level as possible. We have a page on calculating hitch height and coupler height to help you find what ball mount would work best. Most light…

You'd need a drop of right at 1 inch to tow the trailer you mentioned level based on the dimensions you listed. The closest to that is a 2 inch drop ball mount like the part #C45331 which fits a 2 inch hitch like you have as well. It has a…

There are a few different ReCurve R3 weight rating options available so I don't know exactly what system you have and if it's properly rated for your trailer with just that info. Your old trailer was rated to weigh up to 4,400 lbs and…

When using the Curt TruTrack Weight Distribution System w/ Sway Control #C17499, which is a great system for your trailer weight and vehicle, you will initially setup your system just like you would a ball mount. So you will measure from level…

I spoke with my contact at Curt who said that the ideal location for the brackets is 28" on your frame from the hitch ball for the Curt TruTrack #C17499. He did say that they designed this Weight Distribution (WD) system so that you have a…