B and W Trailer Hitch Installation - 1999 Chevrolet Silverado Video

For your 2023 Subaru Outback, I recommend the Curt Trailer Hitch item #C69VV. This hitch is custom fit and bolts to your Subaru with included hardware. This is a class III hitch with a 2" receiver. I really like this hitch because it is an…

The Draw-Tite #76271 trailer hitch that fits your 2019 Subaru Forester is a straightforward install and any qualified local mechanic should be able to do it easily. We are an online retailer and are not affiliated with any type of installers so there…

All of the aftermarket trailer hitches that we carry for your 2011 Dodge Ram 1500 Bighorn state that they will not fit with a factory installed hitch, however, this typically refers to the factory hitches that hang below the rear bumper. I have heard…

In the trailer world GTW stands for Gross Trailer Weight, and TW means tongue weight. Gross trailer weight is the entire weight of the trailer and tongue weight is the amount of vertical load that is on the coupler of the trailer. Basically how the…

I checked the owner's manual for your 2009 Chevrolet Silverado 1500 and the gross combined weight rating (GCWR) of your vehicle is 13,000 lbs. The best way to determine your towing capacity is to load your truck with all the people and cargo that…

Because tail light #STL42RB has more than one function it has more than one amperage draw rating. Brake lights and turn signals draw more power so that will be the higher draw at 0.413 amps. Running lights use less power and would be the 0.26 amps.…

It is possible to use a weight distribution system and air spring suspension enhancement together in a 2013 Ford F-250 or F-350 Super Duty, though if you are experiencing sag with a weight distribution system, it may not have the proper rating for…

The highest capacity 2 inch hitch ball we offer that has a 1-1/4 inch diameter shank is going to be the Curt #A-90 which has a 10k capacity. It is interesting that a 1 inch shank diameter ball #40038 has a 12k capacity yet has a smaller shank, but…

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

We don't have the specific number but what I think will be more helpful for you is the distance from the rear most portion of the bumper to the hitch pin hole. Which for the #41932 that dimension is 1-1/2 inches. Check out the picture I attached…