Trailer Hitch Installation - 2011 Chevrolet Silverado - Curt C15323 Video

A lot of the trailer hitches available for the 2013 Chevrolet Silverado fit a span of over multiple years as long as the generation does not change. For example the etrailer.com Trailer Hitch Receiver part #e98849 fits 1999 - 2013 Chevrolet…

All of the aftermarket trailer hitches that we carry for your 2011 Dodge Ram 1500 Bighorn state that they will not fit with a factory installed hitch, however, this typically refers to the factory hitches that hang below the rear bumper. I have heard…

In the trailer world GTW stands for Gross Trailer Weight, and TW means tongue weight. Gross trailer weight is the entire weight of the trailer and tongue weight is the amount of vertical load that is on the coupler of the trailer. Basically how the…

I checked the owner's manual for your 2009 Chevrolet Silverado 1500 and the gross combined weight rating (GCWR) of your vehicle is 13,000 lbs. The best way to determine your towing capacity is to load your truck with all the people and cargo that…

Yes! You can use Bearing Buddies on anything as long as you use the right size and as long as the axles are not EZ Lube axles with the grease fittings on the ends of the spindles. If your outer bearings are L44643, L44649, or L44640 then you can use…

There is some foam inside the towing mirror housing for #CTM1600 to protect the factory mirror. The foam should compress when pushing the towing mirror on. The outer edge of the factory mirror should be close to the contour of the towing mirror. It…

The highest capacity 2 inch hitch ball we offer that has a 1-1/4 inch diameter shank is going to be the Curt #A-90 which has a 10k capacity. It is interesting that a 1 inch shank diameter ball #40038 has a 12k capacity yet has a smaller shank, but…

The factory hitch that came with your GMC Sierra 1500 was at least a Class III and possibly a class IV depending on what trim level you have. Looking at the available products as well as your specific application and towing needs, I recommend…

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

Yes. The "C" in front of the part number, #C15323, is just how we designate it as a Curt part. The Class IV and V trailer hitches available for your 2009 GMC Sierra 1500 all set at approximately the same location. That is to say with a…

The Roadmaster Quiet Hitch for 2 Inch Trailer Hitches #RM-061 referenced in your question can be used with your weight distribution shank without causing any issues. You will just position the U-bolt around the top of the hitch receiver and place the…

Curt does offer a Class V hitch that is a confirmed fit for your 2006 Chevy Silverado 1500 HD as the part #C15323 but the part #C15302 is not listed as a fit so it's not the hitch you'll want. I attached an install video for this hitch on a…