Trailer Hitch Installation - 2003 Volkswagen Jetta Video

All three of the hitches you referenced are essentially the same thing and would use the same installation points. The part number 24680 and 77027 are now obsolete but have been superseded by the #24748 that you referenced. If you go the #24748 you…

If the 99 year Volkswagen Jetta was the 99.5 mid-year update then yes, a hitch from it like the Curt #C11070 would also fit a 2001 Volkswagen Jetta. If it was an early model Jetta then it would not carry over.

Both the Curt and the Draw-Tite Class I hitches for your vehicle are very similar in appearance and function. When installed, the receiver on either model would sit just below the bottom of the rear bumper. The available ground clearance below the…

In order to install Curt Hitch, part #11070, you will need to undo the exhaust, probably just at the rearmost rubber hanger. This will provide some room to manipulate the hitch into place, and easier access to holes when tightening bolts.

The Curt Trailer Hitch #11083 and #11070 are very similar. But there is one important difference. If you look at them side by side, you will notice that #11083, which will fit your 2003 VW Jetta Wagon, has a receiver tube that is attached under the…

Actually, all of the available hitches for any model of the 2002 VW Jetta have the same rating. They are rated for 200 pounds tongue weight capacity and 2,000 pounds gross trailer weight. However, they are not interchangeable among models. The…

On this page under the "helpful info" heading you'll see the install video I attached for the Draw Tite hitch part #24748 that you referenced which does fit your 2001 Volkswagen Jetta. We do not have trailer wiring install…

With the B&W Turnoverball Underbed Gooseneck Trailer Hitch #BWGNRK1100 that is made for your 1997 Ford F-250 without the overload springs, you can cut 10" off the mounting brackets in the event that you do add overload springs. This…

The one really big downside to gooseneck towing is that there isn't a great solution for short bed truck clearance unlike fifth wheel towing. With fifth wheel hitches you can use a slider hitch and have the clearance issue handled. With…

The problem with putting a gooseneck hitch in a truck with a body lift is that the gooseneck hitch mounts to the frame, and as you know a body lift will lift the body higher off of the frame. Well, a gooseneck hitch installs onto the frame and the…

The body lift definitely complicated getting a gooseneck hitch installed as the rails for the B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit #BWGNRK1059 will attach directly to the frame of your truck. As i am sure…

First thing you should do at this point is test the 4-way of the wiring harness with a circuit tester part #PTW2993 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached. If the voltage…