Customers compare ETBRK210C to these similar products
Info for these parts were:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
The spoke with Dexter and the code "D100G" tells me you have two 10,000 lb trailer axles. I have attached some parts you may need for the axle below. Dexter Trailer Hub Drum Assembly (After July 2009) - part #8-430-5UC3 Dexter Trailer Hub…
view full answer...The #99 trailer spindle is typically found on 9,000 lb and 10,000 lb axles. This is not a spindle that we carry at this time, but I did find some of the measurements. I have attached a diagram showing the dimensions of a #99 spindle for you to check…
view full answer...Thank you for the picture! I reached out to my contact at Dexter and your axle is indeed a 10000lb axle, but with the axles age they were unable to confirm the oil seal or bearings used. With that said your axle being a general duty 10000lb axle…
view full answer...For replacement caliper shoulder bolts for the caliper part #BP18-050 you'd want the part #BP18-105 and you'd be set.
view full answer...There difference between the Kodiak #K2R1258L12 and #K2R1058D11E disc brake kits is the application and the capacity. Both kits provide E-coated calipers and caliper mounting brackets. The #K2R1058D11E is meant for a 10K dexter axle, the #K2R1258L12…
view full answer...To replace your AL-KO 568303 seal you will want the Oil Seal #91030. This seal has the same inner diameter of 2.750 inches and outer diameter of 3.779 inches. It is a confirmed fit for your #99 spindle that uses the AL-KO 568303 seal.
view full answer...The biggest difference between Dexter brake assembly #23-459 and etrailer/AxleTek assembly #AKEBRK-7L-SA is the pad material. The Dexter assemblies use pads that are snapped off of a long strand of the material. The ones on the etrailer assemblies…
view full answer...Yes, the left and right hand assemblies of the kit part number #AKEBRK-10 are available as part numbers #AKEBRK-10R for the right hand side and part #AKEBRK-10L for the left hand side. The kit does not include anything beyond just the two assemblies…
view full answer...You cannot really go by miles when determining when brakes should be replaced. You would know to replace them the same way you would know with a vehicle. If performance is suffering and adjusting the brakes does not help and there are no other issues…
view full answer...We recently had a short training session in which the difference between our brakes such as #AKEBRK-10R and Dexter brakes were revealed. The biggest difference is the brake pad material. It is thicker on our house brand brakes. Also, on our brakes…
view full answer...The Trailer Hub & Drum Assembly #8-388-80UC3 you were looking at is designed specifically for 42mm Dexter Nev-R-Lube axles and you do not grease any of the components. This hub has sealed bearing cartridges which do not get greased. Now if you…
view full answer...There is no specific torque rating for shackle bolts. You'll want to ensure that the bolts you use are long enough so that when installed you will have at least 2 threads protruding from the nut. Make sure that the bolt you're using has a…
view full answer...