etrailer Self-Adjusting Electric Trailer Brake Kit Review Video

Yes, the left and right hand assemblies of the kit part number #AKEBRK-10 are available as part numbers #AKEBRK-10R for the right hand side and part #AKEBRK-10L for the left hand side. The kit does not include anything beyond just the two…

There are a number of reasons why the brakes on your trailer may not be working. Lets start with the easiest things to check. First, check the vehicle and trailer connectors for corrosion. This can cause a short inside the connector and the brake…

I currently have three diffrent self-adjusting assemblies for your boat trailer with 10" x 2-1/4" electric drum brakes which are attached for you below. eTrailer Electric Trailer Brake Kit part #AKEBRK-35-SA (3,500 Axles) Dexter…

Yes, the self-adjusting version of the Dexter Electric Trailer Brake Assembly part #23-181 is the Dexter Nev-R-Adjust Electric Trailer Brake Assembly part #23-465. This assembly is for the right hand side and if you need the left hand side you can…

For replacement Dexter manual adjust brake assemblies to replace your 36-19 you would want the part #23-27 for the right hand side and part #23-26 for the left hand side. These are manual adjust 10 by 2-1/4 inch Dexter brake assemblies that would…

The biggest difference between Dexter brake assembly #23-459 and etrailer/AxleTek assembly #AKEBRK-7L-SA is the pad material. The Dexter assemblies use pads that are snapped off of a long strand of the material. The ones on the etrailer assemblies…

It sounds like you may have weighed the truck first and then attached the trailer and weighed the truck and trailer together on the scale; that would be the only way I can think of that you would get 12,000 lbs. What you want to do is weigh your…

When installing rubber or nylon bushings like the Dexter #K71-372-00 in your leaf springs or equalizers, you'll want to use a block of wood or something that will protect the bushing, while hitting it with a hammer until it seats into the spring.…

You need the Wheel Retaining Ring #33-52-1 for your 10K axles and wheels. This ring has the single tab and will allow you to use your current flat faced wheel with Coned Lug Nuts #6-109. The retaining ring will sit outside the the wheels(see image).…

To tighten the spindle nut on the end of your spindle, go ahead and put your Hub Assembly, like part #8-288-3UC1, on your spindle. Tighten it down to about hand tight and then back it off about 1/4 of a turn. Backing it off helps to keep everything…

Thank you for the picture! I reached out to my contact at Dexter and your axle is indeed a 10000lb axle, but with the axles age they were unable to confirm the oil seal or bearings used. With that said your axle being a general duty 10000lb axle…

I spoke with my rep at Dexter axle and was informed your axle has a 3,500 lbs weight capacity, with a 58" spring center, and a 72" hub face. A comparable replacement is the Dexter Trailer Idler Axle Beam with EZ-Lube Spindles - 72"…