Roadmaster Base Plates RM-032 Review Video

Yes, you can flat tow a vehicle with a Roadmaster base plate with a Blue Ox tow bar as long as you get the correct adapter like the part #RM-032 to connect the two. This is the style of adapter for the Roadmaster base plates that have to use a…

We have heard of this issue before on the Lippert Ground Control systems #LC358590. Here is the recommended procedure for clearing the error code: Extend all jacks at least 6 inches. Then press and hold the RETRACT button until the jacks begin…

I spoke to my contact at Blue Ox, she said that they will service your tow bar if it is less than 8 years old. To determine how old it is she said there is an engraving on the bottom of the driver's side leg that will have the model #, serial…

The Roadmaster Crossbar-Style Base Plate Kit - Fixed Arms Item #118-1 is a confirmed fitting base plate for your 1994 Geo Tracker and to attach it to your Reese tow bar you'll need the Roadmaster Tow Bar Adapter #RM-025. To flat tow you'll…

According to the owner's manual of your 2020 Chevy Silverado 1500, Step 11 of the instructions to dinghy tow, it says: "If the vehicle has an ignition key, keep it in the towed vehicle in ACC/ACCESSORY to prevent the steering column from…

From the research I did it looks like a drive shaft disconnect is recommended for flat towing your 2002 S-10. This is surprising to me though since typically manual transmission vehicles are good to go as-is for flat towing. All you usually have to…

Take a look at the video I have linked on the ladder mount bike carrier #LA-102. We load two bikes on it in this demonstration video. Basically, we put on the second bike the same as the first bike.

If your 2006 Ford Ranger is an XL or XLT then use #483-1 for base plates. Use #477-1 if it's a Sport model or #477-5 for the STX. All of these sets are compatible with the Blackhawk 2 tow bar #RM-422 The tow bar is rated for 10,000 pounds. You…

Everything I was able to find on your 2007 Ford Ranger 2WD manual transmission is that it is flat-towable. Also worth mentioning is that the owners manual for the vehicle is the final word on this matter. If the owners manual says it's fine then…

On the top panel of the Furrion Transfer Switch #F50ATS is a diagram that shows how it will wire to your Weekend Warrior. I also attached a second picture that shows what's underneath the lid.

The distance between the mounting holes center to center on part #RM-032 is 28-1/2 inches. For part #RM-033, the distance from outside to outside of the bolt holes is 25-1/2 inches.

Thank you for the pictures. The base plate kit on the 2007 Jeep Wrangler in the pictures, does not have any identifiable markings. But after comparing the pictures to the base plate kits that fit the 2007 Jeep Wrangler, it does appear to be a Blue Ox…