Review of TRC Enclosed Trailer Parts - 362549-955 Video

It's possible the left and right side brake assemblies were installed on the opposing/incorrect side they are intended for. While this would not change how the magnets power up it can negatively affect braking. If that's not the case, you may…

If you are referring to two white wires from the brake magnet that are coming from the rear of each electric brake assembly, then it would not matter which wire is connected to ground and which wire is used for the brake feed. The magnet that…

The H-Channel for Enclosed Trailer #36281-955 is specifically designed for use with building cabinets and doors on a trailer. It is a sturdy aluminum that will will work well with the door frame as it is rust proof and will not corrode like…

I went to the warehouse and checked out the Fan-Tastic Vent Roof Vent w/ 12V Fan, part #FV802250. The fan motor on the vent has a 3-amp draw. This fan is designed to fit roofs that are up to 4-inches thick and the rough opening size you need for this…

Using a junction box makes installing new 7-way wiring much easier. Often times, people will run the wires from a 7-way such as yours to a junction box like part #38656. From there, they will run the standard wire colors to the trailer lights, brakes…

I spoke to TRC and they said the inside channel of the H-Channel for Enclosed Trailer part # 36281-955 is 1.027" wide.

You can use a tow bar like the Tow Ready #63180 to tow your 2004 Wrangler, but keep in mind, the tow bar is NOT rated for speeds above 45 mph, so I'd recommend a different setup. In order to run at highway speeds, I recommend using a tow bar like…

I believe the Blue Ox tow bar you are referring to is the Blue Ox Alpha Tow Bar #BX7365 rated for 6,500 lbs. There are a variety of base plate kits available for your 2004 Jeep Wrangler and the correct one all depends on what kind of bumper you have.…

Trailer axle nuts don't have a torque rating as you don't want to run them down super tight. The trick is to tighten the nut till there's no play in the hub in and out with the wheel installed and then use the cotter pin to hold the nut…

To add a third brake light to a trailer is pretty simple, but does require an adapter to convert the signal. Because trailer tail light systems combine the stop lamp and turn signals for each side onto a single circuit, you will need to use a…

Good news, I can help pick out led lights for your livestock trailer. My favorite interior light that I would recommend for you is the part #ILL08COB. This light is super bright and since it uses LEDs instead of incandescent bulbs it hardly draws any…

Appreciate the photos, and yes, the trim you asked about does look to be exactly what you are needing: - Even Rub Rail Trim for Enclosed Trailer - 1-1/2" Tall x 1/8" Deep - Aluminum #36284-955 This trim is 93-1/2" long, so if…