Review of Optronics Trailer Lights - Clearance Lights - OPT29FR Video

With having 22'6" from your tail light location to the tongue on your trailer I recommend going with at least a 30' wiring harness. The additional length is needed so you will be able to route your wiring on the frame to the lights and…

The Optronics LED Trailer License Plate Light with Bracket #OPT97FR would normally be mounted to the surface of a trailer. The the only way to power this light using the Curt Auxiliary LED Indicator Lights #C53201 would be to splice into the running…

If you look on the frame of your trailer there should be a plate with the trailer VIN number and the axle capacities of the trailer. You will want to pick leaf springs that are as close to the axle capacity as possible. You will want to also measure…

In regards to the Mini LED Identification Light Kit for Trailers part #OPT29FR, you will need to remove the grommet from the light and then push the light through the hole. Then, you can reinstall the grommet securing the light inside the hole.

The dimension you inquired about is shown on the linked diagram. The spindle-center to frame mounting point on the Timbren axle-less suspension system #A20RS545 is 2-5/8-inches. If you wish you can see various other dimensional drawings on the…

Yes, I am happy to say that we do carry clearance lights/identification lights that do not have the brake light function. That part is the Mini LED Identification Light Kit for Trailers - Submersible - Amber LEDs - Clear Lens #OPT89FR. These lights…

For your trailer wiring, I recommend the Submersible LED Trailer Light Kit w 25' Wiring Harness #TL16RK along with the Identification Light Kit for Trailers over 80" Wide - Submersible - 3 LEDs - Red #MCL22RK3B. I recommend the Sealed, Thin…

The bronze bushings and wet bolts are a great option but they still do require maintenance especially under the conditions you referenced. There really isn't any new information in comparing it is basically the difference between maintenance…

It really just depends on what you are looking to get out of the bushings. Bronze bushings, like part #K71-291-00, will last longer but are more noisy and it is recommended to use wet bolts like part #126B2 to keep them lubricated. Nylon bushings,…

In general shackle bolts turning from use over time does not considerably wear out components. As long as the bolts are greased normally the movement from standard use would not cause them to wear out. The tension of the bolt and nut is loose enough…

It sounds like the axles were attached with 2 inch U-bolts that are 1/2 inch diameter which are a standard size so it sounds like the axles are compatible with a standard U-bolt kit like the CE Smith U-Bolt Kit for Mounting 2" Square Trailer…

I took a walk to our warehouse so I could check out the Optronics LED License Plate Light Kit #LPL12CKM2B. I measured the two mounting holes and they are just over 4mm in diameter so 4mm diameter hardware would be a good fit. Since this light is…